GE X-9 owner manual Cross-fader and fader controls, Effect, menu, etc. management

Page 9

2 Getting acquainted with the X-9

Cross-fader and fader controls

These take care of the A and B outputs which are assigned to the cross-fader using the ASSIGN con- trols, and then passed to the master stereo output.

It is possible to set the cross-fader curve, reversal, and allow source starting with the cross-fader.

See “Cross-fading” on page 14 for details of how the cross-fader fits into the signal chain.

See “Faders” on page 21 for details of cross-fader settings.

Effect, menu, etc. management

This section handles the effects, the parameter menus and the equalization memories of the X-9.

See “EQ” on page 28, “Effects” on page 23 and “Menu reference” on page 17 for details.

TASCAM X-9Owner’s Manual 9

Image 9

Contents Professional Digital DJ Mixer Important Safety Precautions Important Safety Instructions Table of Contents Introduction Some notes and precautionsSerial number, etc Environmental considerationsGetting acquainted with Road map to front panel functionsProgram gain level, EQ and assignment section Sampler section Microphone controlCue selection keys and monitor keys Master fader Program fadersExternal effect Effect, menu, etc. management Cross-fader and fader controlsRecord turntables ConnectionsCD decks, etc Digital connectionsMicrophone connection and use Booth outputsFootswitches Headphones connecting and usingExternal effects unit Fader start/stop connectionsTo use the external effects unit External effectsAbout programs Learning moreCross-fading Assigning sources to programsSignal flow Adjusting the output volume Playing a songCue previewing sounds Menu reference How the X-9 shows charactersMenus Values Program EQ QMeter release time Meter peak holdPresets Restore factoryMic balance Program 1 balanceProgram fader curve FadersProgram fader direction Fader startCross-fader curve Cross-fader startCross-fader reverse Selecting the effect type EffectsEditing the effects Beat parameterEffect parameters LPFaStoring effects Recalling stored effect settings Samplers Recording a samplePlaying back samples Editing samples Erasing samplesSample pitch EQ Q setting Viewing EQ settingsCutting the EQ bands Remembering and recalling EQ settings Specifications Specifications, etcAudio I/O Control I/OGeneral specifications Audio specificationsDimensional drawing Case mounting Mounting the X-9 in a rackEtc Block diagramPage Teac Corporation