GE X-9 owner manual Cross-fader curve, Cross-fader start, Cross-fader reverse

Page 22

6 Faders

Cross-fader curve

You can change the way in which the signal is changed from the A to B signals as the cross-fader is moved, using the C.F CURVE control.

When this control is fully counter-clockwise, it takes a relatively large movement of the cross-fader from

one side towards the center before the opposite cross- fader signal level is increased.

When this control is fully clockwise, the opposite cross-fader signal is heard after only a small move- ment of the cross-fader towards the center.

Cross-fader start

When either of the cross-fader start menus (6cFA or 7cFb) has been set (is on, the C.F START switch is on the ON position) and a suitable connection has been made from the FADER START jack on the rear panel which corresponds to the program number selected), moving the cross-fader to the A and B source automatically starts that source.

Alternatively, press and hold down one of the FUNCTION keys and the corresponding ENTER key together.

While holding the ENTER and FUNCTION keys down, press the EXT EFFECT key to toggle cross- fader A start on or off.

While holding the ENTER and FUNCTION keys down, press the STEREO/MONO SPLIT key to tog- gle cross-fader B start on and off.

These methods are equivalent to the menu settings, and changing the settings in this way will also change the menu settings.

Use the C.F START switch in the OFF position to override the menu settings. In

other words, if the switch is OFF, and the

menu settings are on, cross-fader start is disabled. However, setting this switch to ON will not automati- cally enable cross-fader start if the menu setting is not set to on.

Cross-fader reverse

The C.F REVERSE switch is used to reverse the direction of the cross-fader. When the switch is set to ON, the direction of the cross-fader is reversed (that is, mov-

ing it towards A makes the B signal louder and the other way round). The cross-fader start is also reversed (see “Cross-fader start” on page 22).

22 TASCAM X-9Owner’s Manual

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Professional Digital DJ Mixer Important Safety Precautions Important Safety Instructions Table of Contents Serial number, etc Some notes and precautionsIntroduction Environmental considerationsRoad map to front panel functions Getting acquainted withProgram gain level, EQ and assignment section Microphone control Sampler sectionCue selection keys and monitor keys Program faders Master faderExternal effect Cross-fader and fader controls Effect, menu, etc. managementCD decks, etc ConnectionsRecord turntables Digital connectionsBooth outputs Microphone connection and useExternal effects unit Headphones connecting and usingFootswitches Fader start/stop connectionsExternal effects To use the external effects unitCross-fading Learning moreAbout programs Assigning sources to programsSignal flow Playing a song Adjusting the output volumeCue previewing sounds How the X-9 shows characters Menu referenceMenus Meter release time Program EQ QValues Meter peak holdMic balance Restore factoryPresets Program 1 balanceProgram fader direction FadersProgram fader curve Fader startCross-fader start Cross-fader curveCross-fader reverse Editing the effects EffectsSelecting the effect type Beat parameterLPFa Effect parametersStoring effects Recalling stored effect settings Recording a sample SamplersPlaying back samples Erasing samples Editing samplesSample pitch Viewing EQ settings EQ Q settingCutting the EQ bands Remembering and recalling EQ settings Audio I/O Specifications, etcSpecifications Control I/OAudio specifications General specificationsDimensional drawing Mounting the X-9 in a rack Case mountingBlock diagram EtcPage Teac Corporation
Top Page Image Contents