GE X-9 owner manual Specifications, etc, Audio I/O, Control I/O

Page 30

10 – Specifications, etc.

I/O specifications

Audio I/O

Analog inputs

LINE 1 through LINE 4	RCA pin (unbalanced)
Input level	–16 dBV

Input impedance	47 kΩ

PHONO 1 through PHONO 4	RCA pin unbalanced (with additional SIGNAL GND connector)

Input level	–54 dBV

Input impedance	47 kΩ

MIC input	XLR balanced (female)a
Input level	–55 dBV

Input impedance	2.7 kΩ

RETURN (L, R)	1/4” jack (unbalanced)

Input level	–10 dBV

Input impedance	22 kΩ

Analog outputs

MASTER OUTPUT (BALANCED)	XLR balanced (male)a
Output level	+ 4dBu

Output impedance	75 Ω

MASTER OUTPUT (UNALANCED)	RCA pin (unbalanced)

Output level	–10 dBV

Output impedance	1 kΩ

BOOTH OUTPUT	RCA pin (unbalanced)

Output level	–10 dBV

Output impedance	1 kΩ

SEND (L, R)	1/4” jack (unbalanced)

Output level	–10 dBV

Output impedance	1 kΩ

PHONES (x 2)	Stereo 1/4” jack

Maximum total output level	30 mW + 30 mW

Total load impedance	32 Ω

Digital inputs

CH 1, CH 2	RCA pin, IEC60958 TYPE I or TYPE II (auto-detect)

Digital output

DIGITAL OUT	RCA pin, IEC60958 TYPE II (SPDIF)

a. All XLR connectors are wired 1=ground, 2-live (hot), 3=return (cold)

Control I/O

FADER STOP/START 1 through 4 3.5 mm mini-jack (high=5 V, Low (on)=0 V) Tip=PLAY, GND=READY

FOOT SW 1, FOOT SW 2

1/4” jack (for use with RC-30P)

30 TASCAM X-9Owner’s Manual

Image 30

Contents Professional Digital DJ Mixer Important Safety Precautions Important Safety Instructions Table of Contents Serial number, etc Some notes and precautionsIntroduction Environmental considerationsGetting acquainted with Road map to front panel functionsProgram gain level, EQ and assignment section Sampler section Microphone controlCue selection keys and monitor keys Master fader Program fadersExternal effect Cross-fader and fader controls Effect, menu, etc. managementCD decks, etc ConnectionsRecord turntables Digital connectionsBooth outputs Microphone connection and useExternal effects unit Headphones connecting and usingFootswitches Fader start/stop connectionsExternal effects To use the external effects unitCross-fading Learning moreAbout programs Assigning sources to programsSignal flow Adjusting the output volume Playing a songCue previewing sounds How the X-9 shows characters Menu referenceMenus Meter release time Program EQ QValues Meter peak holdMic balance Restore factoryPresets Program 1 balanceProgram fader direction FadersProgram fader curve Fader startCross-fader curve Cross-fader startCross-fader reverse Editing the effects EffectsSelecting the effect type Beat parameterEffect parameters LPFaStoring effects Recalling stored effect settings Samplers Recording a samplePlaying back samples Editing samples Erasing samplesSample pitch EQ Q setting Viewing EQ settingsCutting the EQ bands Remembering and recalling EQ settings Audio I/O Specifications, etcSpecifications Control I/OAudio specifications General specificationsDimensional drawing Mounting the X-9 in a rack Case mountingBlock diagram EtcPage Teac Corporation