Installing Bridge on
Model H6082/83
Components Needed | Qty |
Guitar | 1 |
Bridge | 1 |
Stopbar Tailpiece | 1 |
Threaded Inserts | 4 |
Tailpiece Adjustment Screws | 2 |
Bridge Adjustment Screws | 2 |
Tools Needed |
|
Hammer | 1 |
Small Wooden Block | 1 |
To attach the bridge to the guitar body: |
|
1.Place two inserts into the forward holes as shown in Figure 23.
Figure 23. Threaded insert placement.
2.Place the wooden block on an insert and lightly tap the insert down until it touches the top of the guitar body. Repeat for the other insert.
3.Thread the bridge adjustment screws into the inserts, as shown in Figure 24, and place the bridge over the inserts.
4.Feed the grounding wire from the electronics cavity into the back hole. Hook the end of the wire down so it catches the edge of the hole.
Figure 24. Bridge adjustment screw.
5.Place the remaining inserts into the back holes.
6.Place the wooden block on an insert and lightly tap the insert down until it touches the top of the guitar body. Repeat for the other insert.
7.Thread the bridge adjustment screws into the inserts as shown in Figure 25.
Figure 25. Tailpiece adjustment screw.
8.Slide the tailpiece onto the adjustment screws.
Model H6082, H6083, and H6086 Heirloom Electric Guitar Kits |