Grizzly H6083, H6082 instruction manual Winding Strings on Model H6086, Correct string locations

Page 23

Winding Strings on

the Model H6086

The correct position of the guitar strings is shown in Figure 31. The thin High E string is the "1st" string and the thick Low E string is the "6th".

To install the guitar strings:

1.Cut the ball ends and wraps off of the guitar strings.

2.Insert the strings between the lock block and the front edge of the lock box as shown in Figure 35.

� �

���� ����

� �

Figure 31. Correct string locations.

Components Needed

Qty

Strings

6

Tools Needed

 

Wire Cutters

1

Hex Wrench 3MM

1

Saddle Lock Screw

Fine Tuner

Lock Block

Lock Box

Figure 34. Bridge components.

Figure 35. Strings locked into lock box.

3.Tighten the saddle lock screws.

4.Guide the strings over the nut, and through the hole in the corresponding tuners.

5.Allow only enough slack in the strings for 2-3 rotations around the tuner. Note—If too much slack is allowed, then the strings could wind off the machine head after many successive rotations. If not enough slack is allowed, then the strings may not hold the winding tension.

6.Bend the strings at a right angles across the edge of the machine heads.

7.Rotate the tuners until the strings just begin to hold the winding tension. Note—DO NOT tighten the strings beyond the initial tension- ing at this time. Final tensioning should be completed during the string tuning process.

8.Use wire cutters to cut off the excess string.

Model H6082, H6083, and H6086 Heirloom Electric Guitar Kits

-21-

Image 23
Contents Models H6082, H6083, H6086 Heirloom Guitar KitsPage Table of Contents Safety Contact Info IntroductionForeword Model H6082/3 Parts Parts InventoryH6086 peghead components Model H6086 PartsRecommended Tools & Supplies Supplies/ToolsIdentification Tools Needed AssemblyShaping Headstock on Model H6082/83 Components Needed QtySanding the Neck Sanding the BodyFinishing the Neck To finish the guitar body Finishing the BodyTo install the tuners Installing the TunersTo attach the neck to the guitar body Installing the NeckTo attach the pick guard to the guitar body Installing PickupsTo wire the pickups Wiring the PickupsTo attach the strap buttons to the guitar Strap ButtonsTo attach the bridge to the guitar body Installing Bridge on Model H6082/83To attach the tremolo bridge to the guitar body Installing Bridge on Model H6086To mount the back plate to the guitar body To install the nutMounting Back Plates Gluing the Nut on the Model H6082 and H6083Truss Rod Cover Attaching the Nut on Model H6086Winding Strings on Model H6082/83 To install the guitar stringsCorrect string locations Winding Strings on Model H6086General SET UPNeck Adjustment To adjust the bow of the guitar neckTo step String Height Adjustment for Model H6082/83To adjust the string height Bridge height adjustment String Height Adjustment for Model H6086To adjust the pickups Pickup AdjustmentsTo tune the guitar Spring Adjustment On the Model H6086Tuning To adjust the tremolo springsTo set the intonation Setting IntonationH1300 H1298 H4979 H4977 G7984 H2347 H0736 AccessoriesReference Info H1302H3097-Chromatic Tuner Half-mask respirator and disposable Cartridge filtersWarranty & Returns Model # Order # Warranty CardBOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage Call Today For a Free Full Color Catalog
Related manuals
Manual 36 pages 25.66 Kb