Grizzly Installing Bridge on Model H6086, To attach the tremolo bridge to the guitar body

Installing Bridge on

Model H6086

Components Needed	Qty
Guitar	1
Floyd Rose Bridge	1
Adjustable Insert	2
Spring Claw	1
Tap Screw M5 X 45	2
Spring	3
Tools Needed
Hammer	1
Phillips Head Screwdriver	1
Soldering Iron and Solder	1

To attach the tremolo bridge to the guitar body:

1.Remove the screws from the adjustable inserts and tap the inserts into the holes in the cut-out. Thread the screws into the inserts.

2.Place the bridge in the cut-out shown in Figure 26 with the notches against the adjustable inserts.

Figure 26. Tremolo bridge placement.

3.Flip the guitar body over and place the spring claw in the cavity as shown in Figure 27.

Figure 27. Spring claw placement.

4.Secure the spring claw to the guitar body with two M5 X 45 tap screws. Tighten the screws until the spring claw is 1" from the wall of the cavity. Note—These screws are used to adjust the spring tension.

5.Solder the black wire to the spring hanger.

6.Stretch the three springs from the spring claw to the tremolo bridge as shown in Figure 28.

Figure 28. Correct spring placement.

7.Place the tremolo arm in the socket pointed out in Figure 26, and tighten the nut.

Model H6082, H6083, and H6086 Heirloom Electric Guitar Kits -17-