Turbine Installation | 12 |
|
|
|
|
following designs and their included specifications.
See page 34 in the Appendix for design and specifications.
Ballast Mount
See page 35 in the Appendix for design and specifications.
Turbine Wiring
ELECTRIC SHOCK HAZARD
Disconnect turbine and battery circuits before wiring. Turn off all power before wiring. Failure to follow safety warning could result in serious injury and/or death.
Personal Injury and Property Damage Hazard STOP! If you plan to connect the HONEYWELL™ Wind Turbine to any controller other than the SMARTBOX™ Controller, immediately cease the installation of the HONEYWELL™ Wind Turbine. Failure to follow this warning will void the HONEYWELL™ Wind Turbine warranty and may result in death, personal injury or property damage (including damage to the HONEYWELL™ Wind Turbine).
PROFESSIONAL INSTALLATION required
Installations must meet all local electrical codes. Installations for the equipment should only be performed by a qualified electrician or a licensed and trained WindTronics installer.
The wiring connections between a mounted HONEYWELL™ Wind Turbine, Battery Box and SMARTBOX™ Controller is relatively simple. The following diagram details and specifies the wire gauges required in this installation. It is strongly recommended that a certified and trained electrician performs all the electrical connection. All electrical systems must be grounded in accordance to the National Electric Code (NEC) (or, in Canada, the Canadian Electric Code (CEC)) and local standards. Please refer to the SMARTBOX™ Controller Manual for full details on wiring, connecting and commissioning of the HONEYWELL™ Wind Turbine.
HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev 10