Turbine Installation | 14 |
|
|
|
|
The SMARTBOX™ Controller
The SMARTBOX™ Controller contains all the electronic controls needed to integrate to the home’s electrical switch board circuits. The SMARTBOX™ Controller is housed in a NEMA 3R enclosure and must be mounted on the wall next to the home’s electrical switch board. The SMARTBOX™ has an LCD display and four operational buttons. Details of the function of these buttons is listed in the SMARTBOX™ Controller Manual. Please read the SMARTBOX™ Controller Manual and always consult and use a certified and trained electrician for connections and service.
TIP: The instructions in this section apply to a typical installation. Installation procedures may vary according to your specific application. For special ap- plications, consult a qualified electrician or your WindTronics certified dealer.
IMPORTANT: Installation must be compliant with all local electrical codes. Installation of this equipment should only be performed by a qualified electrician or by a Certified Renewable Energy System Installer.
Figure 2.5 The SMARTBOX™ Controller
HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev 10