8
INSTALLATION
Installing Surround Kit (GS38 or GS43) (Cont.) Installing Hood
INSTALLATION
Continued
2.Remove log packaging from firebox cavity.
3.Align holes in left surround side panel with screen mounting screw holes. Replace 5/16" screen mounting shoulder screws removed in step 1 (see Figure 6). Do not tighten. Install Phillips screws in bottom (see Figure 6). Repeat for right side.
4.Using Phillips screwdriver, remove four screws attaching brass louver. Install one Phillips head screw (included with kit) in each side (see Figure 7).
5.Align top panel screw holes. Install four Phillips screws, do not tighten.
6.For model GS43, align six screw holes in side panels with holes in top panel (see Figure 9). For model GS38, align two screw holes in side panels with holes in top panel (see Figure 9). Insert and tighten screws.
7.Carefully inspect fireplace surround assembly. Make sure each part fits properly. Firmly tighten all screws installed during assembly.
CAUTION: Do not overtighten. Metal can bend, warp, or break under excessive strain.
8.Remove three pieces of brass trim from packaging.
9.Locate four brass screws, two adjusting plates with set screws, and two shims in the brass hardware packet.
10.Align shim under adjusting plate as shown in Figure 10.
11.Slide one end of adjusting plate/shim in slot of top brass trim (see Figure 10).
12.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 10).
13.While firmly holding edges of brass trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
14.Repeat for other side.
Surround Side
Phillips Screws
5/16" Screws
Phillips
Screws
| Brass Louver |
Figure 6 - Attaching Left | Figure 7 - Remove Brass |
Surround Side Panel | Louver |
15.Line up holes in brass trim with holes on side panels of fire- place surround assembly. Attach with
16.Move fireplace insert and surround assembly to masonry fire- place opening. Make sure fireplace insert and surround assem- bly fit properly.
Top Surround
PanelLouverTop Panel
Screw
Holes
Side Panel
Phillips Screws (4) |
|
| |
Figure 8 - Attaching Top | Figure 9 | - Attaching Side | |
Surround Panel | Panels to Top Panel (GS43 | ||
|
| Pictured) |
|
| Adjusting Plate | Set Screws | |
|
| Top Brass | |
Side Brass | Shim |
| |
| Trim | ||
Trim |
|
|
|
Mitered
Edge Slot
Slot
Figure 10 - Assembling Brass Trim
INSTALLING HOOD
Install hood to top of firebox as shown in Figure 11. Use 7 Phillips screws provided.
Screws
Figure 11 - Installing Hood to Firebox
For
.
.com
