Desa VP324, VP325(B) installation manual Unpacking

Page 3

SAFETY INFORMATION UNPACKING

3

SAFETY INFORMATION

Continued

8.Turn fireplace off and let cool before servicing or repairing. Only a qualified service person should install, service, or re- pair this fireplace. Have fireplace inspected annually by a quali- fied service person.

9.You must keep control compartments, burners, and circulating air passages clean. More frequent cleaning may be needed due to excessive lint and dust from carpeting, bedding material, etc. Turn off the gas valve and pilot light before cleaning fireplace.

10.Have venting system inspected annually by a qualified service person. If needed, have venting system cleaned or repaired. See Cleaning and Maintenance, page 18.

11.Keep the area around your fireplace clear of combustible ma- terials, gasoline, and other flammable vapor and liquids. Do not run fireplace where these are used or stored. Do not place items such as clothing or decorations on or around fireplace.

12.Do not use this fireplace to cook food or burn paper or other objects.

13.Do not use any solid fuels (wood, coal, paper, cardboard, etc.) in this fireplace. Use only the gas type indicated on fireplace nameplate.

14.This appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Ca- nadian Electrical Code, CSA C22.1.

15.Do not install fireplace directly on carpeting, vinyl tile, or any com- bustible material other than wood. The fireplace must set on a metal or wood panel extending the full width and depth of the fireplace.

16.Do not use fireplace if any part has been exposed to or under water. Immediately call a qualified service person to arrange for replacement of the unit.

17.Do not operate fireplace if any log is broken.

18.Do not use a blower insert, heat exchanger insert, or other ac- cessory not approved for use with this fireplace.

UNPACKING

The following items are packed inside the firebox. Remove before positioning firebox into framing.

Ceramic Log Pack - Shrink-wrapped on cardboard

Three (3) plastic bags containing lava rock, pan and ember materials

Rear Log (P325/VP325 Models Only) - Remove the two plastic quick ties from around the burner and grate

Grate Stand - Lift off of burner pan

Check all items for any shipping damage. If damaged, promptly inform dealer or distributor where you bought the product.

Safely retain these items for later installation.

For more information, visit www.desatech.com

108660

Image 3
Contents What to do if YOU Smell GAS For Your SafetyVent Decorative GAS Fireplace Natural GASSafety Information Table of ContentsUnpacking Before YOU Begin IntroductionSelecting Location Product SpecificationsPRE-INSTALLATION Preparation ClearancesMantel Clearances and Wall Details Framing Corner Installation GuidelinesTypical B-Vent Configuration Venting InstallationMin Roof Pitch Checking for Proper VentingInstallation Wall Switch InstallationOptional Wireless HAND-HELD Remote Control Installation GAS Line HOOK-UP Installing 9-Volt Battery in Hand-Held Remote Control UnitOvertighten Ember and PAN Material PlacementLOG Placement for P325B/VP325B Models LOG Placement for P324/VP324 ModelsAppliance Enclosure Combustion AIR KIT Model AK4 OptionalAdjusting Glass Doors Installing Optional Glass Door AccessoryTo Turn OFF GAS to Appliance For Your Safety Read Before LightingOperating Fireplace Lighting InstructionsBurner Flame Pattern Pilot AssemblyInspecting Burners Optional HAND-HELD Remote OperationService Hints Cleaning MaintenanceTechnical Service Replacement PartsObserved Problem Possible Cause Remedy TroubleshootingTroubleshooting Observed Problem Possible Cause P324 and VP324 Models Illustrated Parts BreakdownKEY Part Number Description QTY Parts ListBREAKDOWN44 P325B and VP325B Models LOG Assembly Wiring Diagram AccessoriesWarranty Information