Vermont Casting VCS5008 Series, VCS5008BI Lighting the Rotisserie Burner if applicable, Grill

Page 16

Operation

Lighting the Rotisserie Burner (if applicable)

The Rotisserie burner provides the steady, even heat required to cook poultry and roasts to self-basted perfection.

WARNING

Never stand directly over the Grill when lighting the main burners, to avoid exposure to possible flare-ups.

TO START THE ROTISSERIE BURNER:

1.Always open the Hood completely before attempting to light the Grill.

2.Always confirm that all of the burner control knobs are in the OFF position before opening the gas supply.

3.Turn on the Propane Tank Valve at the tank (1 to 2 turns) or turn on the main natural gas supply valve.

4.Turn the Rotisserie Burner Control Knob to the HIGH position, by pushing down on the knob and turning it counterclockwise.

5.Immediately push the Igniter Button. The Rotisserie burner should light within five seconds.

IF THE ROTISSERIE BURNER DOES NOT LIGHT, immediately turn the burner control knob to the OFF position, to prevent gas buildup. Wait five (5) minutes for the gas to clear and then repeat the preceding starting procedure. If the burner will not light when using the Igniter, follow the match lighting

instructions below.

6.Confirm that the burner is properly lit and that the flame pattern is as desired. Refer to Figures 9a, 9b & 9c for the proper flame patterns. If the flame pattern is other than normal, consult the Troubleshooting Guide on Page 22 for corrective action.

7.Always preheat the Grill before starting to cook on the rotisserie.

MATCH LIGHTING THE ROTISSERIE BURNER:

1.

Always open the Hood completely, before attempting to light

Figure 11

 

the Grill.

 

 

2.

Always confirm that all of the burner control knobs are in the

 

 

OFF position before opening the gas supply.

 

3.

Turn on the Propane Tank Valve at the tank (1 to 2 turns) or

 

 

turn on the main natural gas supply valve.

 

4.

Insert a lit match or a butane lighter into the match lighting

 

 

hole located below the rotisserie screen. (Fig. 11)

 

5.

Turn the Rotisserie Control Knob to the HIGH position by

 

 

pushing down on the knob and turning it counterclockwise.

 

Rotisserie Lighting Hole

B130

Page 9

50004581

Image 16
Contents USER’S Manual Parts Identification Model VCS5008Signal Words Important WarningsB149.1, Natural Gas and Propane Installation Code Safe Locations for USE of this Outdoor GrillSafe USE of Propane LP GAS Safe USE of Natural NG GASSafe USE of Natural NG GAS SafetyPrevention of Burns Electrical Safety Battery HandlingTable of Contents Propane GAS Fuel Propane GAS Fuel Always keep cylinders out of reach of childrenGas Hookup Connecting the Grill to a Propane LP GAS CylinderHooking Up to the Propane LP Gas Supply Connecting the Grill to the Main GAS Supply Hooking Up the Grill to the Natural NG Gas SupplyTo Connect To DisconnectOperation Control FunctionsPropane Tank Valve Burner Control Valves FigLighting the Main Burners Ers, to avoid exposure to possible flare-upsIf the Selected Burner does not Light Clear and then repeat the precedingFLARE-UPS Turning the Burners OffMatch Lighting the Main Burners Lighting the Rotisserie Burner if applicable To Start the Rotisserie BurnerMatch Lighting the Rotisserie Burner GrillRotisserie Setup if equipped Lighting the Side Burner if applicable Rotisserie SetupShutting the Burner OFF Methods of Cooking CookingHard boiling soups, lobsters or corn on the cob. c Preparing Food for the Grill Grilling Tips Cooking Time Chart Type of Food Weight Cooking Cooking TimeType of Food Weight Type of Food Care & Maintenance Care & CleaningSide Burner if applicable Rotisserie Burner if applicableCooking Grids Stainless Steel Panels Drip TrayPorcelain Enamel Castings Maintenance Burner AdjustmentTroubleshooting Guide Problem Potential Cause Action RequiredTroubleshooting Guide Limited Lifetime Warranty Year WarrantyPorcelain Coated Firebox and Rear Lid Assembly Cast Iron Cooking Grates Side Burner All Remaining Parts