GE Monogram ZGG420LBPSS owner manual Cooktop burner grates, Grill lights, To replace, To remove

Infrared sear burner

(on some models)

After each use, it is important to operate the burner on HI for 5 minutes with the hood open to burn away any food particles or drippings.

Some ash may accumulate on the burner surface over time. Occasionally brush, blow or vacuum the debris from the surface of the burner. Only perform this operation when the burner is completely cool.

NOTICE: To prevent damage to the burner:

•Always make sure that the protective screen is properly in place on the infrared burner.

•Never allow water to contact the infrared burner.

Infrared sear burner with protective screen

Cooktop burner grates

(on some models)

The enameled cast-iron burner grates should be cleaned regularly.

Wash them in hot soapy water, rinse and dry thoroughly.

The grates can also be cleaned inside an oven during a self-clean cycle, or in a dishwasher. The frames may be cleaned by hand or in

the dishwasher.

Although they are durable, the grates may dull over time, regardless of the best care you can give them. This is due to their continual exposure to high temperatures.

Do not operate a burner for an extended period of time without cookware on the grate. The finish on the grate may chip without cookware to absorb the heat .

Grates (reversible for wok cooking)

Frame

Pads

Grill light(s)

	For stability, the frames have rubber pads on
	each corner. During cleaning and use, be careful
	not to damage or snag rubber pads.
CAUTION: Allow the grill and light	To replace
	Use a new 12-volt halogen bulb, with G4 base,
assembly to cool completely before replacing.
	not to exceed 10 watts. IMPORTANT: Higher
For your safety, do not touch a hot bulb with
	wattage bulbs will blow the fuse. See the Fuse
bare hands or a damp cloth.
	Replacement section.

Each grill is equipped with a halogen light(s) located above the warming shelf.

The light assembly consists of a removable glass light cover and a locking clip.

To remove:

1.Remove the light cover by pulling its right edge down. NOTE: The locking clip may fall from the light cover. It will need to be replaced properly.

Locking clip

Retaining tab

Replacement bulbs may be purchased by calling 800.626.2002. Order Part Number WB08X10060.

1.Using gloves or a dry cloth, remove bulb from its packaging. Do not touch bulb with bare fingers. Push bulb straight into receptacle all the way.

2.Place left edge of cover under retaining tab. Roll right side up making sure that the clip seats in place. NOTE: If the locking clip fell from the cover, hold it in place on the cover while replacing.

Cover must always be in place when using grill.

2.Using gloves or a dry cloth, remove the burned-out bulb by pulling it straight out .

Clean the cover frequently using a wet cloth. This should be done when the grill is completely

cool. 25