The Grill
Professional Outdoor Grills & Cooktops
Location
Allow 12" minimum clearance on both sides and the back of the grill to adjacent vertical combustible construction. See the Installation Instructions for complete details.
Tank drawer with LP tank retainer loop
To install the LP tank, fully extend the tank drawer and lift the retainer loop. Place the tank on the drawer bottom, inserting the loop on the bottom of the tank through the hole in
the drawer bottom. Tilt the tank forward to lower the retainer loop to engage the top ring on the tank. Insert the coupler sleeve on the regulator over the tank inlet; turn clockwise to tighten.
Do not overtighten the coupler (see Installation Instructions). Open the tank valve when ready to use the grill. Always close the tank valve when cooking is complete.
Before lighting the outdoor grill or cooktop
WARNING: IMPORTANT!
Inspect the gas supply piping or hose prior to turning the gas on. If there is evidence of cuts, wear or abrasion, it must be replaced prior to use. Any replacement pressure regulator
or hose assembly must be the type specified by the manufacturer.
For LP use, the pressure regulator and hose assembly supplied with the unit must be used.
This LP tank is equipped with overfill protection. When you refill or trade in your tank, make sure the one you receive also has overfill protection.
If the grill uses LP gas, connect the regulator
to the LP tank and check the hose and regulator connections for leaks with a soap and water solution before operating the grill.
Keep a spray bottle of soapy water near the gas supply valve and check the connections for gas leaks before each use.
Turn all knobs to OFF then turn on the gas supply.
Do not use the grill if the odor of gas is present.
Temperature | The temperature gauge is meant to be a general |
|
gauge | indicator of surface temperatures with the hood |
|
in the closed position. It is especially useful |
| |
| during |
|
| become stable (approximately |
|
| with all main burners on Hi). |
|
| NOTE: On models equipped with the Infrared |
|
| Sear Burner, the temperature gauge will not |
|
| respond when only that burner is turned on. |
|
| For the 54" grill model, the temperature gauge | Temperature gauge |
| will not respond if only the far left main burner | |
|
| |
| is turned on. |
|
Main | The grill section consists of stainless steel grill |
|
grill | grates, stainless steel heat diffusers and |
|
stainless steel main burners. |
| |
burners | The grates provide the grilling surface. |
|
|
|
The heat diffuser helps protect the main burner ports from blockage and distributes heat .
Each main burner is rated at 25,000 BTUs.
Main burner | Heat diffuser | Grill grates |
|
|
12