Gas Hook-Up, Installer Final Check List

GAS HOOK-UP

5.When connecting regulator assembly to the valve, hand tighten the quick coupling nut clockwise to a complete stop. Do not use a wrench to tighten. Use of a wrench may damage the quick coupling nut and result in a hazardous condition.

6.Open the tank valve fully (counterclockwise). Use a soapy water solution to check all connections for leaks before attempting to light the grill, see below. If a leak is found, turn the tank valve off and do not use the grill until a local L.P. gas dealer can make repairs.

To disconnect L.P. gas cylinder:

1.Turn the burner valves off.

2.Turn the tank valve off fully (turn clockwise to stop).

3.Detach the regulator assembly from the tank valve by turning the quick coupling nut counterclockwise.

INSTALLER FINAL CHECK LIST

9Specified clearance maintained 24”(61cm) from combustibles.

9All internal packaging removed.

9Knobs turn freely.

9Burners are tight and sitting properly on orifices.

9Pressure regulator connected and set. Gas connections to grill using hose & regulator assembly provided (pre-set for 11.0” water column).

9Unit tested and free of leaks.

9User informed of gas supply shut off valve location

USER, PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

PROPANE CYLINDER CAUTIONS

a)Do Not store a spare LP-gas cylinder under or near this appliance.

b)NEVER fill the cylinder beyond 80 percent full.

c)If the information in “a” and “b” is not followed exactly, a fire causing death or serious injury may occur.