GRILL LIGHTING INSTRUCTIONS
TO LIGHT THE GRILL BURNER:
Make sure all knobs are “OFF” then turn on the gas supply from the LP tank. Always keep your face and body as far from the grill as possible when lighting.
Your stainless steel grill has an exclusive patented
WARNING: Always keep your face and body as far away from the burner as possible when lighting.
TO LIGHT THE SIDE BURNER
To light the side burner, remove any cooking utensils from the burner grate. Push and turn the control knob counterclockwise to the “IGNITE/HI” position. If the burner does not light, turn the control knob to “OFF”. If the smell of gas is detected and the igniter is not functioning, immediately turn the control knob “OFF”. Allow 5 minutes for any accumulated gas to dissipate. If the side burner igniter is not functioning, see the following section for match lighting.
If you’ve just attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. Keep your face and hands as far away from the grill as possible. Insert a lit match attached to the lighting rod through the cooking grids to the burner.(see next page) Press the control knob and rotate left to the IGNITE/HI setting, continue to press the knob until the burner ignites. Burner should light immediately. If the burner does not light in 4 seconds turn the knob off, wait 5 minutes and try again.
TO MATCH LIGHT THE SIDE BURNER
Hold a lit extended match or lighter near the side burner ports, turn the control knob counterclockwise to “IGNITE/HI”. Move your hand immediately once the burner is lit. Rotate the control knob to the desired setting.
TO LIGHT THE ROTISSERIE BURNER:
Open the lid; push and turn the knob to the “IGNITE/ON” position. While holding in the knob, push electronic igniter to light the rotisserie burner. Once the burner is lit, continue to hold in for another 15 seconds to be sure the burner stays lit. If the burner does not light, turn the control knob to “OFF”. If the igniter does not function, follow the instruction above for match lighting
TO MATCH LIGHT THE GRILL
If the burner will not light after several attempts then the burner can be match lit.
Lighting rod instruction: Match light extension rod
Use this device to match light your burners
Simply place a lighted match between the coils on the end of the extension rod and hold next to the burner to ignite.
Keep a spray bottle of soapy water near the gas supply valve and check the connections before each use.
Do not attempt to light the grill if odor of gas is present. Call for service
17