Assembly - General
Assembly Instructions for Princess PI1010A Insert
There will be local building and fire codes which could affect this installation. Be sure you check with your local building inspector, fire inspector or other local authorities having jurisdiction in your area before you begin instal- lation. This insert is certified only for installation into a masonry fireplace or factory built fireplace listed to UL 127 or ULC S620 which have been carefully inspected and are in good condition.
Blaze King recommends that you use a qualified Blaze King installer to assemble and properly install your PI1010 insert. Technicians are certified by the HPBA in the USA and by WETT in Canada.
Provide protection for the hearth to prevent damage while sliding the heavy insert in and out of the fireplace opening.
1) Carefully remove and inspect the insert parts from the shipping packages. The parts should include the fireplace insert, (see Fig. 1) 2 shroud side panels, 1 shroud top panel, 1 shroud outer trim package, 1 shroud convection deck, 2
Figure 1 | Figure 2 |
2)Place the fireplace insert on the work area , the unit is shipped without any shroud parts in place. Attach the
Figure 3
Page 18 | DATE PRINTED: 2/8/05 | Revision Date: 02/01/05 |