Troubleshooting
Your Blaze King is designed to allow a wide selection of heat output levels. If you begin to lose control of the amount of heat the stove is emitting, determine the cause early so that major problems may be avoided.
The six major needs of a
1.Knowledgeable, interested operator.
2.Adequate air supply.
3.Firewood of good quality and proper size.
4.Catalytic combustor in good condition.
5.Clean chimney, properly sized and installed.
6.Door gasket tight and firm.
Considering all of the above, number one is the most important for safe and efficient operation of any wood- stove. Please study the operation instructions carefully. Consult your BLAZE KING dealer by calling the Cus- tomer Service Department at Blaze King in the U.S.A. at
All of the six above mentioned needs are interrelated. A deficiency in any one will affect all of the others. If you encounter a problem, determine the source of the problem and then
PROBLEM: | Chimney Fire |
CAUSE | SOLUTION |
Act immediately regardless of cause | Turn the thermostat to lowest setting, check |
| loading door to be sure it is tightly closed. |
| Call Fire Department. |
After the fire is out, have your chimney and flue connector inspected by a certified chimney sweep. A damaged masonry chimney should be repaired or rebuilt. A prefabricated chimney (factory built) that is damaged should be replaced. Any damage to the flue connector should be corrected before the system is used again.
Possible causes of a chimney fire, and remedies for those causes, can be found further in this section: "Excessive Creosote Formation", and "Spots of Creosote Accumulation in Chimney or Flue Connector".
PROBLEM: | Not enough heat. |
CAUSE | SOLUTION |
Green or wet wood. | Use seasoned wood. Don't be afraid to |
Not enough fuel in stove. | FULLY load the stove. The thermostat will control the burn rate |
| regardless of load size. |
Obstruction in chimney or cap screen. | Remove obstruction. Test combustor, page 26 |
Combustor plugged or coated. | Clean combustor, page 26. Detailed cleaning instructions are also |
| available at www.blazeking.com. |
Combustor not functioning. | Test combustor, page 26. |
| If needed, replace combustor, page 27. |
Thermostat set too low. | Raise thermostat setting. |
Thermostat not operating properly. | Consult your Blaze King dealer. |
Poor draft caused by an oversize flue. | Measure draft with Manometer. |
| See CHIMNEY DRAFTS, page 9 & 21. |
| See CHIMNEY, page 8. |
| Consult your Blaze King dealer or a chimney sweep. |
Strong, gusting winds causing | Install |
chimney downdrafts. | may not stay freely rotating If you have a directional |
| cap, check it frequently. |
Tightly sealed house, | Open a window slightly, near the stove. There must be an adequate |
inadequate air supply. | fresh air supply to ensure proper combustion. |
Reloading too much wood on top | Allow a larger bed of coals to build up. |
of too few coals. |
|
|
|
Page 29 | DATE PRINTED: 2/8/05 | Revision Date: 02/01/05 |