LEAK TESTING INSTRUCTIONS |
DANGER
Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, damage to property, serious bodily injury or death.
LEAK TESTING: This must be done before initial use, annually and whenever any gas components are replaced or serviced. Do not smoke while performing this test, and remove all sources of ignition. See Leak Testing Diagram for areas to check.
1.Turn all burner controls to off. Turn supply valve on.
2.Brush a half and half solution of liquid soap and water onto all joints and connections of the regulator, hose, manifolds and valves.
3.Bubbles will indicate a gas leak. Either tighten the loose joint or have the part replaced with one recommended by the customer care department.
4.If the leak cannot be stopped, shut off the gas supply, disconnect it and have the barbecue inspected by your gas supplier or dealer. Do not use the appliance until the leak has been corrected.
5.Turn off gas supply.
A LEAK TEST MUST BE PERFORMED AT THE FOLLOWING TIMES:
•BEFORE INITIAL USE EVEN IF THE GRILL WAS DEALER ASSEMBLED.
•AT LEAST ONCE PER YEAR.
•WHENEVER ANY GAS COMPONENT HAS BEEN REPLACED.
30 |