22
FIREPLACE INSTALLATION
Installing Logs, Lava Rock, and Glowing Embers Wall Switch Installation
FIREPLACE INSTALLATION
Continued
INSTALLING LOGS, LAVA ROCK AND GLOWING EMBERS
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass door. See Removing/Replacing Glass Door, steps 1 and 2 on page 21. Install logs according to instructions for fireplace model numbers.
1.Place log #1 (left base log) onto pin on left side of burner as shown in Figure 39.
2.Place log #2 (right base log) onto pin on right side of burner as shown in Figure 39.
3.Place logs #3 (left front log) and log #4 (right front log) onto pins as shown in Figure 40.
4.Place log #5 (right rear log) onto pins on right rear of burner (see Figure 41). Rest log #6 (middle crossover log) on top of log number 2 as shown in Figure 41.
5.Place back end of log #7 (left rear log) onto pin on left rear burner and rest front onto log #1 as shown in Figure 42.
6.Rest log #8 (left crossover log) onto log #3 and rest log #9 (right crossover log) onto logs #4 and #5 as shown in Figure 43.
7.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely and sparingly directly onto the exposed front section of the burner (see Figure 44). This will create the glowing ember appearance as the flame touches the ember material. Do not block air slots by using too much ember material in one area. It is not necessary to use all of the ember material provided.
NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner will cause perfor- mance problems.
8.Close glass door, lock door latches, replace screen, and close louvers (see Removing/Replacing Glass Door, steps 5 through 7 on page 21).
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
2 | 3 |
1 | 4 |
| |
Figure 39 - Installing Logs | Figure 40 - Installing Logs |
No. 1 and No. 2 | No. 3 and No. 4 |
5 | 7 |
| |
6 |
|
Figure 41 - Installing Logs | Figure 42 - Installing Log No. 7 |
No. 5 and No. 6 |
|
9
8
Figure 43 - Installing Logs No. 8 and No. 9
Ember Material
Figure 44 - Placing Ember Material on Burner
WALL SWITCH INSTALLATION
The installation of a wall switch allows you to activate the gas control valve and turn the fireplace on and off. The wall switch is to be connected to the incoming 120 volt regular household wiring that supplies the electricity to the fireplace. Refer to wiring diagram below.
For
.
.com
