Desa VMH10RNC Specifications, Wiring Diagram, Replacement Parts, Service Hints, Technical Service

Page 35

SPECIFICATIONS

		CGCF10PR		CGCF10NR
	VMH10TPC	VMH10RPC	VMH10TNC	VMH10RNC
	EFS10TPA	EFS10RPA	EFS10TNA	EFS10RNA
Btu/Hr	10,000	10,000	10,000	10,000
Type Gas	Propane/LP	Propane/LP	Natural	Natural
Ignition	Electronic Ignitor	Electronic Ignitor	Electronic Ignitor	Electronic Ignitor
Manifold Pressure	8.5" W.C.	8" W.C.	3" W.C.	3.5" W.C.
Inlet Gas Pressure
(in. of water)
Maximum	14"	14"	10.5"	10.5"
Minimum*	11"	11"	5"	5"
Dimensions, inches (HxWxD)
Fireplace		25 7/8 x 26 13/16 x 9 3/8
(including hood and screws)
Carton		32 5/8 x 27 13/16 x 11 5/8
Weight, pounds
Fireplace	44 1/2 lbs.	44 1/2 lbs.	44 1/2 lbs.	44 1/2 lbs.
Shipping	48 lbs.	48 lbs.	48 lbs.	48 lbs.

* For purpose of input adjustment

WIRING DIAGRAM

(REMOTE-READY MODELS ONLY)

Jumper Wire

REPLACEMENT PARTS

Note: Use only original replacement parts. This will protect your warranty coverage for parts re- placed under warranty.

TPTH TH

Gas Control

TPTH TP

Red

Thermopile

White

SERVICE HINTS

When Gas Pressure Is Too Low

•pilot will not stay lit

•burners will have delayed ignition

•fireplace will not produce specified heat

•for propane/LP units, propane/LP gas supply may be low

You may feel your gas pressure is too low. If so, con- tact your local natural or propane/LP gas supplier.

TECHNICAL SERVICE

You may have further questions about installation, operation, or troubleshooting. If so, contact DESA Heating Products’ Technical Service Department at 1-866-672-6040. When calling, please have your model and serial numbers of your heater ready.

You can also visit DESA Heating Products’ tech- nical services web site at www.desatech.com.

PARTS UNDER WARRANTY

Contact authorized dealers of this product. If they can’t supply original replacement part(s), call DESA Heating Products’ Technical Service De- partment at 1-866-672-6040.

When calling DESA Heating Products, have ready

•your name

•your address

•model and serial numbers of your fireplace

•how fireplace was malfunctioning

•type of gas used (propane/LP or natural gas)

•purchase date

Usually, we will ask you to return the part to the factory.

PARTS NOT UNDER WARRANTY

Contact authorized dealers of this product. If they can’t supply original replacement part(s), call DESA Heating Products at 1-866-672-6040 for re- ferral information.

When calling DESA Heating Products, have ready

•model number of your fireplace

•the replacement part number

112462-01C

www.desatech.com

35

Image 35

Contents What to do if YOU Smell GAS Table of Contents Safety Information Local Codes Unpacking Product FeaturesOptional Remote Control Accessories Product IdentificationHood Tabs Louver Baffle Sheet Metal Screws Firebox Top AssemblyAssembling Fireplace Shoulder Screw ScreenConfined and Unconfined Space AIR for Combustion VentilationProviding Adequate Ventilation Ventilation Air From Inside Building Determining FRESH-AIR Flow for Fireplace LocationVentilation AIR Determining if You Have a Confined or Unconfined SpaceVentilation Air from Inside Building InstallationFireplace Clearances Installation ItemsCheck GAS Type Example BUILT-IN Fireplace InstallationMinimum Clearance to Combustible Materials Flanges Mantel Clearances for Built-In InstallationIf you have not assembled firebox, follow in- structions on Optional Mantel Installation Removing Upper Louver Installing Optional Blower Accessory GA3450TInstalling Blower Accessory Assembling Trim Trim shipped with mantelPower Cord Snap Bushing Wire HarnessScrew Wiring Routing Hole Baffle Extension Cord For Built-In InstallationDoor Connecting to GAS SupplyAttaching Wood Base to Solid Floor IncludedPropane/LP Test Pressures In Excess Of 1/2 Psig 3.5 kPa Connecting Fireplace to GAS SupplyInstallation Items Needed Checking GAS ConnectionsEquipment Gas Regulator or Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPaEquipment Shutoff Valve ClosedInstalling 9-Volt Battery in Hand-Held Remote Control Unit Optional Wireless HAND-HELD Remote Control AccessoriesInstalling Receiver Terminal W Terminal R R Control Valve Jumper Wire One terminal of 25 ft. wireFeed wires through rectangular slots Shoulder Screw Log Screen Installing LOG SET and ScreenOperating Fireplace Ignitor Thermocouple Lighting InstructionsElectronic Ignitor Button Control Knob Thermocouple Ignitor Electrode Pilot BurnerThermostat Control Operation Manual Lighting ProcedureREMOTE-READY Models For Your Safety Read Before Lighting To Turn OFF GAS To AppliancePilot Burner Ignitor Electrode Control Knob Electronic IgnitorPilot Ignitor Burner Electrode ON/OFF Series Model Ghrcb Optional HAND-HELD Remote OperationGWMT1 Wall Mounted Thermostat Optional GWMS2 Wall Mounted Switch OptionalThermostat Series Model Ghrctb Pilot Burner Thermocouple Inspecting BurnersPilot Flame Pattern Burner Flame PatternCabinet Cleaning MaintenanceBurner Injector Holder and Pilot AIR Inlet Hole LOG SETTroubleshootiing Observed Problem Possible Cause RemedyTroubleshooting Hours of operation Bris. If found, clean burnerResidues from manufactur Tial operationGas leak. See Warning Service Hints SpecificationsWiring Diagram Replacement PartsIllustrated Parts Breakdown Install Battery According To This IllustrationTHERMOSTAT-CONTROLLED Models Parts List935 Parts Available not Shown Accessories Corner Mantel with Full Hearth Base WALL-MOUNT ON/OFF Switch GWMS2Receiver and HAND-HELD Thermostat Remote Control KIT Ghrctb Receiver and HAND-HELD Remote Control KIT Ghrcb112462-01C 112462-01C Limited Warranty VENT-FREE Compact Classic Hearth Fireplace Warranty InformationKeep this Warranty