Desa CDV41N/P, CDV37N/P installation manual Plug in blower power cord

OWNER’S MANUAL

FIREPLACE INSTALLATION

Continued

8.Plug in blower power cord.

a.If your fireplace system is installed as a freestanding unit with an ac- cessory mantel, determine whether the power cord will exit the left side or the right side of the firebox. In- stall one plastic bushing provided into the 1 1/2" hole in the outer cas- ing through which the power cord will exit. Install the second plastic bushing provided into the floor sup- port bracket if exiting through the right side (see Figure 33). Route power cord through (both) plastic bushing(s) and plug the power cord into a properly grounded 3-prong wall receptacle near the firebox.

b.If your fireplace system installation is recessed and/or pre-wired, a qualified installer must make all elec- trical connections for the outlet kit included with the fireplace.

9.Check to make sure that the power cord is completely clear of the blower wheel and that there are no other foreign ob- jects in blower wheel. Turn blower on and check for operation. Turn blower off by rotating knob fully counterclock- wise before continuing.

WARNING: Never touch the blower wheel while in operation.

10.Peel off the backing paper and stick the supplied wiring diagram decal on the firebox bottom approximately 3" to the right of the blower speed control bracket (Figure 33).

Thermal Switch

WARNING: Failure to position the parts in accordance with sup- plied diagrams or failure to use only parts specifically approved with this heater may result in dam- age or personal injury.

11.Connect or reconnect gas supply to fire- place per Connecting Fireplace to Gas Supply on page 19 of this manual.

WARNING: A qualified ser- vice person must connect fire- place to gas supply. Follow all local codes.

Firebox Bottom	Firebox Back
	Firebox Flange
Thermal	Blower
Switch

Side View

Lower Rear

Wall of

Firebox

Wrapper

Lower Louver

Blower Panel

Screws

Exhaust Port

Top

Mounting

Tab

Figure 30 - Mounting Blower to Firebox

Figure 31 - Locating Thermal Switch Against Back of Firebox

Speed

Control

Control

Knob

Control Shaft

Locknut

Figure 32 - Attaching Speed Control to Firebox

Blower	Plastic
	Bushing
Speed
Control
Bracket Wiring
Diagram
Figure 33 - Installing Plastic Bushing and Wiring Diagram Sticker		Continued

105541 17