Desa DCFTNA For Built-In Installation, Test to make sure blower is working properly, Lower louver

INSTALLATION

Continued

For Built-In Installation

WARNING: A licensed elec- trician must connect the wiring harness to electrical supply following all local codes. Electri- cian must provide a clamp on the box cover to secure the wiring. Wiring should be routed through the bushing in the hole on the outer casing of fireplace.

1.Install snap bushing from blower kit into one hole on rear of remote/blower bracket (see Figure 18). The other hole is for a strain relief clamp (not supplied) to secure incoming electrical supply.

2.Follow steps 2 through 6 in Installing Blower Accessory, page 14.

3.A licensed electrician must follow the wiring diagram to connect incoming electrical supply to fan kit wiring harness (see Figure 19).

4.Plug power cord to outlet receptacle (not provided) as shown in Figure 18. Wind extra cable of power cord and tie up with plastic wire strap (see Figure 18). Set cable bundle between the remote/blower bracket and outer casing, away from the burner.

5.Test to make sure blower is working properly.

6.Reinstall upper louver beginning with bottom screws (see Figure 12, page 12) and close

lower louver.

Fan Switch
(Auto/Off/On)
	1	Auto
Off	2
		3	Blue	Thermostat
		On		Switch
				(N.O.)
110/115				Blue
V.A.C.		Red		Blower
Black				Motor
				Red
White				White
Green				Green

Figure 19 - Wiring Diagram For Blower Accessory Built-In Installation

Extension Cord Use extension cord if needed. The cord must have

athree-prong, grounding plug and a three-hole receptacle. Make sure cord is in good shape. It must be heavy enough to carry the current needed. An un- dersized cord will cause a drop in line voltage. This will result in loss of power and overheating. Use a No. 16 AWG cord for lengths less than 50 feet.

Blower Bracket Wire Harness

Assembly

Screw

Power Cord

Switch

Outlet Receptacle (not included)

3 2 1

Switch

Plate

Plastic Wire Strap Wire Harness

Clamp Connector (not included)

Remote/ Blower Bracket

Lower Louver Door

Figure 18 - Installing Blower Bracket Assembly

111244-01E www.desatech.com 15