Desa VDCFTPB, VDCFRNB Optional Hand-Held, Remote Operation, Thermostat Series Model, HRC200

Locks System to Prevent Accidental Ignition

OPERATING FIREPLACE

Continued

optional Hand-Held

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, page 40). Follow instructions included with the remote control.

Indicator Light

Control Button

NOTICE: You must light the pilot
before using the hand-held re-		Figure 42 - ON/OFF Hand-Held Remote
mote control unit. See Lighting
Instructions on page 23.			Control Unit
		Thermostat Series (Model
1. After lighting, let pilot flame burn for
		HRC200)
about one minute. Turn control knob to
		The hand-held remote can be operated using
ON position. Adjust flame adjustment knob
anywhere between HI and LO. Slide the		either the manual mode (MANU) or thermo-
selector switch to the REMOTE position		static mode (AUTO) (see Figure 43). To select
(see Figure 41). Note: The burner may light		Fahrenheit/Centigrade mode display, carefully
if hand-held remote was on when selector		press the ˚C/˚F mode button with the end of a
switch was last turned off. You can now		paper clip or similar blunt object.
turn the burner on and off with the hand-		Indicator	Digital Display Shows
held remote control unit.		Light	Temperature and Settings
IMPORTANT:Do not leave the selectorswitch
in the REMOTE or ON position when the
pilot is not lit. This will drain the battery.				AUTO
Flame	Control		ROOM	SET
			TEMP	TEMP
Adjustment Knob	Knob

Selector Switch in Remote Position (Optional Remote Control)

Figure 41 - Setting the Selector Switch,

Control Knob and Flame Adjustment

Knob for Remote Operation

On/Off Series (Model HRC100)

Hold the control button on the hand-held remote until burner turns on. Hold the control button again until burner turns off (see Figure 42).

To Lock press both buttons on hand-held remote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

To Unlock press both buttons together on hand-held remote control until the light stops flashing. The hand-held remote is now unlocked.

	LOCK	TEMP		POWER
	MANU		ºC/ºF	AUTO
Turns
Burners					Turns
On or
					Hand-Held
Off
					Remote On
					or Off and
Increases or	°C/°F				Allows You
Decreases				Selects	to Choose
Room	Mode			AUTO	the Manual
Temperature	Button				Setting
				Mode
in AUTO Mode

Figure 43 - Thermostat Hand-Held

Remote Control Unit

Manual Mode

1. Press the POWER and LOCK buttons together to turn on the hand-held remote control.

2. Press the MANU button to turn on the fireplace.

3. Press the POWER and LOCK buttons together to turn off the fireplace.

116526-01B www.desatech.com 25