Leak Testing Procedure

Installation Assembly/

Perform a leak test at least once a year whether the gas supply cylinder has been disconnected or not. In addition, whenever the gas cylinder is connected to the regulator or whenever any part of the gas system is disconnected or replaced, perform a leak test.

As a safety precaution, remember to always leak test your fireplace or firepit outdoors in a well-ventilated area. Never smoke or permit sources of ignition in the area while doing a leak test. Do not use a flame, such as a lighted match to test for leaks. Use a solution of soapy water.

1.Prepare a leak testing solution of soapy water by mixing in a spray bottle one part liquid soap to one part water.

2.Make sure all the control knobs are in the OFF position.

3.Turn on the gas.

On natural gas systems, turn the main feed valve to the burn- er.

On LP systems, turn the cylinder valve knob counter clockwise one turn to open.

4.Apply the leak-testing solution by spraying it on joints of the gas delivery system. Blowing bubbles in the soap solution indicates that a leak is present.

5.Stop a leak by tightening the loose joint or by replacing the faulty part with a replacement part recommended by the manufacturer. Do not attempt to repair the cylinder valve if it is damaged. The cylinder must be replaced.

6.Turn the control knob back to the full OFF position.

If you are unable to stop a leak:

1.Turn the control knob back to the full OFF position.

2.Shut off the gas supply to the fireplace or firepit and release pres- sure in the hose and manifold by turning the control valve one quarter turn counter-clockwise.

3.On LP systems, remove the cylinder from the fireplace or firepit.

4.Call an authorized gas appliance service technician or an LP gas dealer.

Do not use the appliance until the leak is corrected.

2009 Fireplaces and Firepits

www.calspas.com

LTR20091006, Rev. B