20
Using GrillYour
•Do not use this appliance if any part has been under water. Imme- diately call a qualified service technician to inspect the appliance and replace any part of the control system and any gas control which has been under water.
•Make sure the ignitor battery has been installed properly. Ignitor will not operate properly without a battery installed.
Lighting Instructions for Automatic Starter
1.Remove protective storage cover and locate the manual gas con- trol valve and igniter button on the fireplace.
2.Make sure fuel supply is properly connected and turned on at the source.
3.Depress igniter button until you hear it sparking. You will hear a small popping noise. Keep igniter button pushed in while slowly turning the fuel flow valve to the full flow position at the fireplace. The fireplace should light within 5 seconds. If you do not hear the igniter sparking you may need to replace the battery. The starter uses one standard AAA battery, located directly behind the rubber push button knob. (Unscrew knob to access battery.) Note some models ship with the batteries removed or may not be included with your model.
4.If a flame does not start within 10 seconds, shut off all gas supply and wait five minutes to allow all gas fumes to clear.
2009 Fireplaces and Firepits
www.calspas.com | LTR20091006, Rev. B |