Assem ly Step 2
Burner
ChamberCabinet
AssemblyAssembly
|
|
3 Required | 3 Required |
1.With the cabinet in the upright position, begin by removing the door panel from the cabinet assembly by lifting it from the hinges. Set the door panel aside. This will make assembly much easier.
2.Set the cabinet assembly top side down. To prevent scratching or damaging your smoker, set the cabinet on a padded surface such as cardboard or carpet. The top of the cabinet has the vent holes; the bottom has mounting holes for the legs.
3.Insert the Burner Chamber Assembly upside down through the bottom of the Cabinet as shown. Be sure the front mounting tab and venturi tube opening is facing the front of the cabinet.
4.Line up the bolt holes and insert the bolts from the inside of the Cabinet as shown.
Loosely thread on the nuts to hold the assembly in place. At this time, DO NOT tighten the bolts completely.
m
Phillips Head Screwdriver
TOP