Great Outdoors 3600G manual Assem ly Step, Iiiiiii

Page 9

Assem ly Step 4

iiiiiii

Ignitor Knob

Control Knob

Control Panel

 

Assembly

Screwdriver

i!

1.Leave the cabinet upside down.

2.Attach the Ignitor Knob and the Control Knob to the control panel as shown. Make

sure the Control Knob properly seats on the keyed shaft.

3.Line up the control panel as shown.

4.The HVR stem must be inserted into the venturi as shown in Figure 1 on the following page.

5.When sliding the control panel into place, make sure the tabs capture the legs as shown in Figure 2 on the following page.

6.Connect the ignitor wire to one

of the prongs on the ignitor as shown in Figure 2 on the following

page.

7.Insert the 2 remaining bolts from Hardware Bag A through the tabs on the Control Panel and thread them into the mounting holes.

8.Firmly tighten all of the bolts and nuts.

9.Carefully turn the smoker upright onto its legs.

Image 9
Contents Video Ssem y a Owners ManuaStatement of Commitment Struct Save ESE Struction Assembly -Identifying the parts Identifying the parts Assem ly Step HAROWAREOAGScrewdriver Iiiiiii Assem ly StepAssem y Step HAROWARE0AG Harowareoag Assembly Step Water Bowl Ly Step Ly Step Assem ly t Connecting e LP Tank Connecting e LP Tan Pre-Use Procedures Operating InstructionsAdding Water Cooking Tip- Flavoring wood Adding Wood / CharcoalIgnitor Lighting System Lighting ProcedureShutting the Smoker Off Cooking Tip Damper AdjustmentsCooking Instructions Meat Mixtures Lloyds Temperature ChartAfter se Safety and aintenance Outdoors