Char-Broil 463230510 Assembly, Flange nuts at rear, 20x2-3/8 Machine Screw Qty, Flange Nut Qty

Page 17

ASSEMBLY

•Place bottom shelf between side panels with cut out hole for LP cylinder on left. Attach to left and right side panels with (4)

1	1/4”-20x2-3/8” machine screws and 1/4”-20 flange nuts at front, and (2) 1/4”-20x2-3/8” machine screws and 1/4”-20

flange nuts at rear.

For Front Door

Brace Assembly

Right Side Panel

Rear

Left Side Panel

1/4"-20x2-3/8" Machine Screw Qty. 6

Front

1/4"-20

Flange Nut

Qty. 6

Bottom Shelf

•Place lower back panel between side panels as shown. Attach to left and right side panels with (4) #8-32x3/8” sheet metal

2 screws. Then attach to bottom shelf with (2) #8-32x3/8” sheet metal screws.

Magnet Assembly

#8-32x3/8"

Sheet Metal Screws

Qty. 6

Left Side Panel

Bottom Shelf

Right Side Panel

Lower Back Panel

Image 17

Contents Date Purchased Estimated assembly time 35-40 minutesThis Grill is for Outdoor USE only Table of ContentsCalifornia Proposition Installation Safety PrecautionsFirst Time Use TemperatureLava Rock / Briquettes Pre-Heating Your GrillDirect Cooking Food SafetyIndirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures General Cleaning Why Clean?Routine Care Storing Your GrillLP Cylinder Filling USE and CareLP Liquefied Petroleum Gas UseDo not household cleaning agents. Damage to gas For your safetyLP Cylinder Leak Test Nipple has to be centered into the LP cylinder valveTurn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator Ignitor Lighting For Safe Use of Your Grill and to Avoid Serious InjurySDo not lean over grill while lighting Open lid during lightingSideburner Ignitor Lighting General Grill CleaningSideburner Match Lighting Burner Flame CheckStoring Your Grill Cleaning the Burner AssemblyVery Important Burner tubes must reengage valve Turn gas OFF at control knobs and LP cylinderItems Manufacturer will not PAY for Limited WarrantyKey Qty Description Parts ListParts Diagram Flange nuts at rear Assembly20x2-3/8 Machine Screw Qty Flange Nut QtyFlange Nut Qty 20x2-3/8 Machine Screw Qty ScrewsMetal Tap Turn assembly upside down 20x1/2 Screw Qty Right side panel removed for clarityScrew 20x1/27mm Fiber Washer Qty 20x1/2 Screw Back Firebox20x1/2 Machine Screw Sideburner Tube #8-32 wing nut#10-24x1/2 Machine Screw Qty Hinge Pin holeLeft Handle 5mm Flat Washer Qty Right Door Left Door 5mm Lock WasherBar Burner Warming Rack Leg Wire Pivot Wire Cooking Grate AA BatteryGrease Tray Heat ShieldLP Cylinder Not included Tank Retainer ScrewProblem TroubleshootingEmergencies Possible Cause Prevention/Solution Possible Cause Prevention/Solution Problem Possible Cause Prevention/SolutionSection Troubleshooting Electronic IgnitionPage Warranty Registration Department Box Columbus, GA