Char-Broil 463230510 manual USE and Care, LP Liquefied Petroleum Gas, LP Cylinder Filling

Page 8
Retainer Strap

USE AND CARE

DANGER

NEVER store a spare LP cylinder under or near the appliance or in an enclosed area.

Never fill a cylinder beyond 80% full.

An over filled or improperly stored cylinder is a hazard due to possible gas release from the safety relief valve. This could cause an intense fire with risk of property damage, serious injury or death.

If you see, smell or hear gas escaping, immediately get away from the LP cylinder/appliance and call your fire department.

LP Cylinder Removal, Transport and Storage

•Turn OFF all control knobs and LP cylinder valve. Turn coupling nut counterclockwise by hand only - do not use tools to disconnect. Loosen cylinder screw beneath bottom shelf, then lift LP cylinder up and out of cart. Install safety cap onto LP cylinder valve. Always use cap and strap supplied with valve.

Failure to use safety cap as directed may result in serious personal injury and/or property damage.

•A disconnected LP cylinder in LP Cylinder Valve

 

storage or being transported

 

must have a safety cap installed (as shown).

 

Do not store an LP cylinder in enclosed spaces

 

such as a carport, garage, porch, covered

Safety

patio or other building. Never leave an LP cylinder

inside a vehicle which may become overheated

Cap

 

by the sun.

•Do not store an LP cylinder in an area where children play.

LP Cylinder

•The LP cylinder used with your grill must meet the following requirements:

Use LP cylinders only with these required measurements: 12" (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum.

•LP cylinders must be constructed and marked in accordance with specifications for LP cylinders of the U.S. Department of Transportation (DOT) or for Canada, CAN/CSA-B339, cylinders, spheres and tubes for transportation of dangerous goods. Transport Canada (TC). See LP cylinder collar for marking.

LP cylinder valve must have:

•Type 1 outlet compatible with

regulator or grill.

•Safety relief valve.

•UL listed Overfill Protection

OPD Hand Wheel

Device (OPD). This OPD safety

feature is identified by a unique triangular hand wheel. Use

only LP cylinders equipped with this type of valve.

•LP cylinder must be arranged for vapor withdrawal and include collar to protect LP cylinder valve. Always keep LP cylinders in upright position during use, transit or storage.

LP cylinder in upright position for vapor withdrawal

LP (Liquefied Petroleum Gas)

LP gas is nontoxic, odorless and colorless when produced. For Your Safety, LP gas has been given an odor (similar to rotten cabbage) so that it can be smelled.

LP gas is highly flammable and may ignite unexpectedly when mixed with air.

LP Cylinder Filling

Use only licensed and experienced dealers.

LP dealer must purge new cylinder before filling.

Dealer should NEVER fill LP cylinder more than 80% of LP cylinder volume. Volume of propane in cylinder will vary by temperature.

A frosty regulator indicates gas overfill. Immediately close LP cylinder valve and call local LP gas dealer for assistance.

•Do not release liquid propane (LP) gas into the atmosphere. This is a hazardous practice.

•To remove gas from LP cylinder, contact an LP dealer or call a local fire department for assistance. Check the telephone directory under “Gas Companies” for nearest certified LP dealers.

8

Image 8
Contents Estimated assembly time 35-40 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionTemperature First Time UseLava Rock / Briquettes Pre-Heating Your Grill Food Safety Direct Cooking Indirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures Why Clean? General CleaningRoutine Care Storing Your GrillLP Cylinder Filling USE and CareLP Liquefied Petroleum Gas For your safety UseDo not household cleaning agents. Damage to gasLP Cylinder Leak Test Nipple has to be centered into the LP cylinder valveTurn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator For Safe Use of Your Grill and to Avoid Serious Injury Ignitor LightingSDo not lean over grill while lighting Open lid during lightingGeneral Grill Cleaning Sideburner Ignitor LightingSideburner Match Lighting Burner Flame CheckCleaning the Burner Assembly Storing Your GrillVery Important Burner tubes must reengage valve Turn gas OFF at control knobs and LP cylinderLimited Warranty Items Manufacturer will not PAY forParts List Key Qty DescriptionParts Diagram Assembly Flange nuts at rear20x2-3/8 Machine Screw Qty Flange Nut QtyFlange Nut Qty 20x2-3/8 Machine Screw Qty ScrewsMetal Tap Turn assembly upside down Right side panel removed for clarity 20x1/2 Screw Qty20x1/2 Screw7mm Fiber Washer Qty 20x1/2 Screw Back Firebox20x1/2 Machine Screw #8-32 wing nut Sideburner TubeHinge Pin hole #10-24x1/2 Machine Screw QtyLeft Handle 5mm Flat Washer Qty Right Door Left Door 5mm Lock WasherWarming Rack Leg Wire Pivot Wire Cooking Grate AA Battery Bar BurnerHeat Shield Grease TrayLP Cylinder Not included Tank Retainer ScrewProblem TroubleshootingEmergencies Possible Cause Prevention/Solution Problem Possible Cause Prevention/Solution Possible Cause Prevention/SolutionTroubleshooting Electronic Ignition SectionPage Warranty Registration Department Box Columbus, GA