Char-Broil 463230510 Heat Shield, Grease Tray, LP Cylinder Not included, Tank Retainer Screw

Page 26

15

B

•Attach the heat shield to grease tray with #8-32x3/8” sheet metal screws (A).

•Place grease pan into grease tray, then place the tray into the cart (B).

A	Heat Shield

#8-32x3/8"	Grease Tray
Sheet Metal Screws
Qty. 2

Grease Tray

Grease Pan

CAUTION

Failure to install grease tray and grease pan will cause hot grease to drip from bottom of grill with risk of fire or property damage.

•LP tank is sold separately. Use only with an OPD (over-fill protection device) equipped LP tank. Fill and leak-check before attaching

16	to grill and regulator. See Use and Care section to correctly Leak Test and perform the Burner Flame Check.

•Place Lp tank into hole in bottom shelf with tank collar opening facing to side as shown. Finger tighten tank retainer screw to hold LP tank securely in place. Insert regulator through the large hole on left side panel.

Always keep LP cylinders in upright position during use, transport, and storage.

CAUTION

Failure to install tank correctly may allow gas hose to be damaged in operation, resulting in the risk of fire.

Regulator

LP Cylinder

(not included)

Cylinder screw at rear of cart

Tank Retainer Screw

LP Tank

26

Image 26

Contents Estimated assembly time 35-40 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionLava Rock / Briquettes TemperatureFirst Time Use Pre-Heating Your GrillIndirect Cooking Food SafetyDirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures Routine Care Why Clean?General Cleaning Storing Your GrillLP Cylinder Filling USE and CareLP Liquefied Petroleum Gas LP Cylinder Leak Test For your safetyUseDo not household cleaning agents. Damage to gas Nipple has to be centered into the LP cylinder valveTurn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator SDo not lean over grill while lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting Open lid during lightingSideburner Match Lighting General Grill CleaningSideburner Ignitor Lighting Burner Flame CheckVery Important Burner tubes must reengage valve Cleaning the Burner AssemblyStoring Your Grill Turn gas OFF at control knobs and LP cylinderLimited Warranty Items Manufacturer will not PAY forParts List Key Qty DescriptionParts Diagram 20x2-3/8 Machine Screw Qty AssemblyFlange nuts at rear Flange Nut QtyFlange Nut Qty 20x2-3/8 Machine Screw Qty ScrewsMetal Tap Turn assembly upside down Right side panel removed for clarity 20x1/2 Screw Qty20x1/2 Screw7mm Fiber Washer Qty 20x1/2 Screw Back Firebox20x1/2 Machine Screw #8-32 wing nut Sideburner TubeLeft Handle Hinge Pin hole#10-24x1/2 Machine Screw Qty 5mm Flat Washer Qty Right Door Left Door 5mm Lock WasherWarming Rack Leg Wire Pivot Wire Cooking Grate AA Battery Bar BurnerLP Cylinder Not included Heat ShieldGrease Tray Tank Retainer ScrewProblem TroubleshootingEmergencies Possible Cause Prevention/Solution Problem Possible Cause Prevention/Solution Possible Cause Prevention/SolutionTroubleshooting Electronic Ignition SectionPage Warranty Registration Department Box Columbus, GA