Electrolux EHG 6412, EHG 6402, EHG 6832 Important safety requirements, Provision for Ventilation

Page 17

electrolux 17

Important safety requirements

This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition).

For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I.S. 813 Current Editions and the ETCI Rules for Electrical Installations.

Provision for Ventilation

Detailed recommendations are contained in the following British Standards Codes Of Practice: B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891 Current Editions.

The hob should not be installed in a bed sitting room with a volume of less than 20 m3. If it is installed in a room of volume less than 5 m3 an air vent of effective area of 100 cm2 is required. If it is installed in a room of volume between 5 m3 and 10 m3 an air vent of effective area of 50 cm2 is required, while if the volume exceeds 11 m3 no air vent is required.

However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m3 and 11 m3.

If there are other fuel burning appliances in the same room, B.S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements.

For appliances installed in the Republic of Ireland please refer to the NSAI- Domestic Gas Installation I.S. 813 Current Editions Table Four.

Image 17
Contents Instruction booklet Page Welcome to the world of Electrolux Contents Installation Important Safety InformationPeople Safety During UseEnvironmental Information ServiceDescription of the Hob Instructions for the User Hob burners control knobs OperationLighting the burners Only for models EHG 641, EHG 6412, EHGElectrolux Burner Minimum Maximum Diameter Using the hob correctlyPan Supports Maintenance and CleaningHob Top Ignition electrode BurnersSomething Not Working? SymptomEngineer technical data Instructions for the InstallerType of GAS Provision for Ventilation Important safety requirementsInstallation Gas Connection Location Seal Fitting the Hob into the WorktopBuilding over a kitchen unit with door BuildingBuilding over a cupboard or drawer This HOB Must be Earthed Electrical ConnectionsPermanent Connection Wiring diagram Preliminary Electrical Systems Check Fault FindingEarth Continuity Check Ignition System / Gas Ignition Procedure Pressure TestingMinimum adjustment CommissioningMethod Conversion from Natural Gas to LPGExclusions Standard Guarantee Conditions0870 5 929 Service and Spare PartsEuropean Guarantee Electrolux Page 35693-1702 10/07 R.A