Aussie 69F6U00KS1 manual Assembly Instructions, Step Attaching the Wheels and Casters

4

Assembly Instructions

!CAUTION

PINCH HAZARD

To reduce the risk of bodily injury from pinch hazard, keep hands and fingers away from hinges, leg pivot points and moving parts. Only open the cart by gripping the top of each leg frame.

Read and follow these instructions to set up your grill.

Step 1

Attaching the Wheels and Casters

A. Place the cart upside down on a clean flat surface. Insert an Axle through a Wheel and both walls of the corner channel. Fasten in place by inserting an Axle Pin through the small hole near the end of the Axle. Snap the Hubcap on to the Wheel. Repeat for other Wheel.

B. Attach the casters to the bottom of the cart as shown with 4) 1/4-20 x .5” Bolts each caster.

Axle Pin

B

A

Hubcap

Axle

Step 2

Attaching Cylinder Bracket

Attach the Cylinder Bracket to the end of the Cart with 2) 1/4-20 x .47” Bolts, oriented as shown.

Step 3

Attaching the Firebox Handles

Place the Handle between the brackets on the end of the firebox and align the slot with the hole. For each side of the Handle, insert a 1/4-20 Shoulder Bolt from the inside so that the shoulder is through the slot in the handle and tight against the firebox bracket. Fasten in place on the outside with a 1/4-20 Locking Nut. Repeat for other Handle.