Black & Decker LST136 Assembly & Adjustment, LI-ION Battery Packs and Chargers, Description

This product can accept any of the batteries and chargers listed in the chart below.

LI-ION Battery Packs and Chargers

Description	Cat. #
Batteries: LI-ION	LBX36
	LBXR36
	LBXR2036
Chargers: LI-ION	LCS36
	LCS436

ASSEMBLY & ADJUSTMENT

WARNING: Before assembly, make sure that the tool is switched off and the battery has been removed.

ASSEMBLY TOOLS REQUIRED (NOT SUPPLIED):

- Phillips Screwdriver

WARNING: Remove the battery before attempting to attach any of the following components.

Attaching the guard	D	D2
(Figures D and E)	D5
WARNING: NEVER
OPERATE TOOL WITHOUT		D1	D6
GUARD FIRMLY IN PLACE.
The guard must always be
properly attached on the tool to		D3
protect the user.
• Remove the screw from the
guard.		D4
• Keeping the guard square to
the trimmer head slide it fully
into place until the retaining			8

tab clicks into place (Ensure that the guide rails (D1) on the guard (D2) are correctly aligned with the guide rails (D3) on the trimmer head (D4) (figure D). The locking tab (D5) should snapped into the housing slot (D6).

• Secure the guard with the screw (E1) (figure E).

Attaching the auxiliary handle (figureS F and G)

• Push the auxiliary handle (F1) onto the tube (F2).

• Slide the bolt (G1) through the holes in the auxiliary handle.

• Tighten the knob (G2) onto the bolt by turning it clockwise.

Adjusting the position of the auxilIary handle (fig. G)

The auxiliary handle can be adjusted to provide optimum balance and comfort.

• Loosen the knob on the bolt by turning it counter clockwise.

• Gently slide the auxiliary handle up or down the tube to the desired height.

• Tighten the knob onto the bolt by turning it clockwise. 

E

E1

F

F1

F2

G

G1

G2