Black & Decker LST136 R R1R2, T T2 T1, S1 S2, Rewinding Spool, in “REPLACING THE SPOOL”

• Align the tabs on the spool cap with the slots (R1) in the housing (figure R).

• Push the cap onto the housing until it snaps securely into place.

CAUTION: To avoid tool damage, if the cutting line protrudes beyond the trimming blade, cut it off so that it just reaches the blade.

R

R1R2

•Insert the 3/4 inch (19mm) end of the bulk line into the hole (T1) in the spool adjacent to the slot as shown in figure T. Make sure the line is pulled tight against the spool as shown in figure T.

T T2 T1

REWINDING SPOOL

(use only .065 in. ROUND diameter line) (figures S, T & U) NOTE: Hand wound spools from bulk line are likely to become tangled more frequently than Black & Decker factory wound spools. For best results, factory wound spools are recommended.

• Wind the cutting line onto the spool in
	U
the direction of the arrow on the spool.
Make sure to wind the line on neatly and
in layers. Do not crisscross (figure U).
• When the wound cutting line reaches
the recesses (T2), cut the line. (figure T).
• Fit the spool onto the tool as described
in “REPLACING THE SPOOL”.

To rewind spool, follow the steps below:

•Remove battery from tool.

•Remove the empty spool from the tool as described in

REPLACING THE SPOOL”.

•Make a fold at the end of the cutting line at about 3/4 inch (19mm)(S1). Feed the cutting line into one of the line holding slots (S2) as shown in figure S.

S

S1

S2

The RBRC™ Seal

The RBRC™ (Rechargeable

Battery Recycling Corporation)

Seal on the Li-Ion battery (or

battery pack) indicates that the costs to recycle the battery

(or battery pack) at the end of its useful life have already been paid by

Black & Decker. RBRC™ in cooperation with Black & Decker and

other battery users, has established programs in the United States

to facilitate the collection of spent Li-Ion batteries. Help protect our

environment and conserve natural resources by returning the spent

Li-Ion battery to an authorized Black & Decker service center or to your

local retailer for recycling. You may also contact your local recycling center

for information on where to drop off the spent battery. RBRC™ is a registered

trademark of the Rechargeable Battery Recycling Corporation.

12