HElpful cutting tips
• Use the tip of the string to do the cutting; do not force string head into uncut grass. Use edge guide along such things as fences, houses and flower beds for best practices.
• Wire and picket fences cause extra string wear, even breakage. Stone and brick walls, curbs, and wood may wear string rapidly.
• Do not allow spool cap to drag on ground or other surfaces.
• In long growth cut from the top down and do not exceed 12 inches (304.8 mm) high.
• Keep trimmer tilted toward the area being cut; this is the best cutting area.
• The trimmer cuts when passing the unit from the right to left. This will avoid throwing debris at the operator.
• Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can easily be damaged by the string.
Cutting Line / LINE FEEDING
Your trimmer uses .065 inch (1.65 mm) diameter, ROUND nylon line. During use, the tips of the nylon lines will become frayed and worn and the special self feeding spool will automatically feed and trim a fresh length of line. Do not bump unit on ground in attempt to feed line or for any other purposes. Cutting line will wear faster and require more feeding if the cutting or edging is done along sidewalks or other abrasive surfaces or heavier weeds are being cut.
replacement accessories
CAUTION: Before you begin trimming, only use the appropriate type of cutting line.
Use Black & Decker replacement spool Model No.
• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON MONOFILAMENT LINE. Do not use serrated or heavier gauge line, as they will overload the motor and cause overheating.
• Other replacement parts (guards, spool caps, etc.) are available
11
through Black & Decker service centers. To find your local service location call:
WARNING: The use of any accessory not
recommended by Black &P2 Decker for use with this tool
could be hazardous.
REPLACING THE SPOOL |
|
|
(figures P, Q and R) |
| |
• Remove battery from | P1 |
|
tool. | P1 | |
• Depress the tabs (P1) and |
| |
remove the spool cap (P2) |
|
|
from the spool housing (P3) |
| P3 |
in the trimmer head (figure P). |
| |
• Replace spool with Black |
|
|
& Decker model |
|
|
• Grasp empty spool with one hand and spool housing with other | ||
hand and pull spool out. |
|
|
• If lever (Q1) in base of | Q |
|
housing becomes dislodged, |
| |
replace in correct position |
| Q1 |
before inserting new spool |
| |
into housing. |
| Q2 |
• Remove any dirt and grass |
|
|
from the spool and housing. |
|
|
• Unfasten the end of the |
|
|
cutting line and guide the line |
|
|
into the eyelet (R2) figure R. |
|
|
• Take the new spool and |
|
|
push it onto the boss (Q2) in |
|
|
the housing. Rotate the spool |
|
|
slightly until it is seated. |
|
|
The line should protrude |
|
|
approximately |
|
|
(122mm) from the housing. |
|
|