Trane WCY042G1, WCY048G1, WCY036G1, WCY030G1, WCY060G1, WCY024G1 manual Maintenance

MAINTENANCE

ROUTINE MAINTENANCE BY OWNER

You can do some of the periodic maintenance functions for your WCY-Gunit yourself; this includes replacing the dispos- able or cleaning the permanent air filters, cleaning the unit cabinet, clearing the condenser coil, and conducting a general unit inspection on a regular basis.

Be sure to inspect them at least once each month when the system is in constant operation. (In new homes, check the filters every week for the first four (4) weeks.)

If you have disposable-type filters, replace them with new filters of the same type and size. Do not attempt to clean

disposable filters.

Permanent-type filters can be cleaned by washing them with a mild detergent and water. Make sure that the filters are thoroughly dry before re-installing them in the unit (or duct system).

NOTE: It may be necessary to replace permanent filters annually if washing fails to clean the filter or if the filter shows signs of deterioration. Be sure to use the same type and size as was originally installed.

CONDENSER COIL

Unfiltered air circulates through the unit's condenser coil and can cause the coil's surface to become clogged with dust, dirt, etc. To clean the coil, vertically (i.e., with the fins) stroke the coil surface with a soft-bristled brush.

Be sure to keep all vegetation away from the condenser coil area.

MAINTENANCE PERFORMED BY SERVICEMAN-- COOLING SEASON

To keep your unit operating safely and efficiently, the manu- facturer recommends that a qualified serviceman check the entire system at least once each year and any other time that you feel one is needed. Your serviceman should examine these areas of your WCY-G unit:

●filters (for cleaning or replacement)

●motors and drive system components

●gaskets (for possible replacement)

●safety controls (for mechanical cleaning)

●electrical components and wiring (for possible replacement and connection tightness)

●condensate drain (for cleaning)

●unit duct connections (to see that they are physically sound and sealed to the unit casing)

●unit mounting support (for structural integrity)

MAINTENANCE PERFORMED BY SERVICEMAN-- HEATING SEASON

Complete the unit inspections and service routines described below at the beginning of each heating season.

●Visually inspect the unit to ensure that the airflow required for condenser coil is not obstructed from the unit.

●Inspect the control panel wiring to verify that all electrical connections are tight and that the wire insulation is intact.

.▲WARNING: TO PREVENT INJURY OR DEATH DUE TO ELECTRICAL SHOCK OR CONTACT WITH MOVING PARTS. LOCK UNIT DISCONNECT SWITCH IN OPEN POSITION BEFORE SERVICING UNIT.

▲WARNING: TO PREVENT AN EXPLOSION

OR POSSIBLE INJURY, DEATH AND EQUIPMENT DAMAGE, DO NOT STORE COMBUSTIBLE MATERIALS, GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS NEAR THE UNIT.

The following warning complies with State of California law, Proposition 65.

▲WARNING: This product contains fiberglass wool insulation! Fiberglass dust and ceramic fibers are believed by the State of California to cause cancer through inhalation. Glasswool fibers may also cause respiratory, skin, or eye irritation.

PRECAUTIONARY MEASURES

●Avoid breathing fiberglass dust.

●Use a NIOSH approved dust/mist respirator.

●Avoid contact with the skin or eyes. Wear long- sleeved, loose-fitting clothing, gloves, and eye protection.

●Wash clothes separately from other clothing: rinse washer thoroughly.

●Operations such as sawing, blowing, tear-out, and spraying may generate fiber concentrations requiring additional respiratory protection. Use the appropriate NIOSH approved respirator in these situations.

FIRST AID MEASURES

Eye Contact	-	Flush eyes with water to remove dust.
		If symptoms persist, seek medical
		attention.
Skin Contact	-	Wash affected areas gently with soap
		and warm water after handling.

●the unit (for obvious unit deterioration)

Page 18