MAINTENANCE
Burner Tube Removal
To remove burner tube(s):
A) Remove igniter wire(s) from igniter clip(s) (7)..7 B) Remove screw that holds burner tube to the cookbox using a flathead screwdriver (8)..
C) Pull burner tube assembly (this includes igniter) up and out of cookbox (9)..
Note: 310/320 units will have an additional grounding wire attached to the center burner tube (10).
Burner Tube Cleaning
To clean the burner tube(s):
A)Look inside each burner with a flashlight (11)..
B)Clean the inside of the burners with a wire (12) (a
C)Check and clean the air shutter opening at the ends of the burners.. Check and
clean the valve orifices at the base of the valves.. Use a steel bristle brush to clean |
| |
outside of burners (13).. This is to make sure all the burner ports are fully open.. | 9 | |
m CAUTION: Do not enlarge the burner ports when cleaning. | ||
|
Burner Tube Reinstallation
To reinstall burner tubes:
A) Slide burner tube and igniter wire through hole in cookbox (14).. Refer to “ELECTRONIC IGNITION SYSTEM OPERATIONS” for proper burner position..
B) Align burner tube with valve..
mCAUTION: The burner openings (15) must be positioned
properly over the valve orifices (16).
C)
D) Route wires back through igniter clips.. Refer back to figure (7)..
m CAUTION: All wires must be properly routed through wire clips.
E) Attach wires to module, following the numerical/color coding (18).. Refer to “ELECTRONIC IGNITION SYSTEM OPERATIONS” for proper attachment of wires..
m WARNING: After reinstalling the gas lines, they should be leak checked with a soap and water solution before using the barbecue. (Refer to “CHECK FOR GAS LEAKS”.)
mWARNING: Make sure that all parts are assembled and
hardware is fully tightened before operating the grill. Your actions, if you fail to follow this Product Warning, may cause a fire, an explosion, or structural failure resulting in serious personal injury or death as well as damage to property. ◆
8
10
11
12
13
15
14
16
17
18
20