Brinkmann 9620 owner manual Match Lighting the Rotisserie Burner, Turning OFF the Grill

Page 13

MATCH LIGHTING THE ROTISSERIE BURNER:

1.Open grill hood before lighting rotisserie burner.

2.Make sure control knob is in the "OFF" position.

3.Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the lower edge of burner.

4.Push and turn the control knob to the "HIGH" position. The burner should light within 5 seconds.

5.If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat lighting procedure.

6.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See "Trouble Shooting" section of this manual.

Note:

On main burners and side burner,

 

observe flame height when lit. Flame should be a Blue/Yellow

 

color between 1"–2" when burner is on "HIGH".

TURNING OFF THE GRILL:

1.Turn off the cylinder valve.

2.Turn all burner control knobs to the "OFF" position.

Note: Turn off LP cylinder first to prevent gas from being left in the system under pressure.

CAUTION!

The cylinder valve should always be in the off, or closed, position when the grill is not in use.

To turn off the cylinder valve, turn knob clockwise until it stops.

12

Image 13
Contents 9620 Important Safety Table of Contents General Warnings LP GAS Cylinder not Supplied with this Grill Installation InformationCylinder Specifications Regulator Resetting Procedure Installing the LP GAS Cylinder Onto the GrillFilling the LP GAS Cylinder Hose and RegulatorConnecting Hose and Regulator Connecting Hose and Regulator to AN LP GAS CylinderWhen to Perform a Leak Test Leak TestingChecking for Leaks PRE-START Check List Lighting the Main Burners Lighting InstructionsMatch Lighting the Main Burners Match Lighting the Side Burner Lighting the Side BurnerLighting the Rotisserie Burner Turning OFF the Grill Match Lighting the Rotisserie BurnerBreaking in Your Grill Operating the GrillPreheating the Grill Controlling FLARE-UPSSide Burner Rotisserie CookingGrilling to Proper Temperature CleanlinessHelpful Hints Burner ASSEMBLY/MAINTENANCE Cleaning and MaintenanceCooking Grills Proper Burner OperationHeat Distribution Plates Transporting and StorageBefore Storing Your Grill Trouble ShootingFrequently Asked Questions Frequently Asked Questions Parts List Assembly InstructionsPage Parts BAG Contents Step Attach four casters to legs. Tighten with wrench Step Step Without leak testing all Step Hang grease cup from brackets ProSeries 9620 Assembled Peligro Importantes Advertencias DE SeguridadÍndice Advertencias Generales Información DE Instalación Especificaciones DEL Cilindro Manguera Y Regulador Llenado DEL Cilindro DE GAS DE Propano LíquidoProcedimiento DE Reposición DEL Regulador Conexión DE Lamangueray Regulador Cuándo Realizar UNA Prueba DE Detección DE Fugas Pruebas DE Detección DE FugasVerificación DE Ausencia DE Fugas ¡PRECAUCIÓN Lista DE Verificación Preliminar AL EncendidoEncendido DE LAS Hornillas Principales Instrucciones DE EncendidoEncendido DE LAS Hornillas Principales CON UN Cerillo Encendido DE LA Hornilla Lateral CON UN Cerillo Encendido DE LA Hornilla LateralEncendido DE LA Hornilla DEL Asador Estilo Rotisserie Apagado DE LA Parrilla ¡CUIDADOPreparación DE LA Parrilla Para Usarla POR Primera VEZ Operación DE LA ParrillaPrecalentamiento DE LA Parrilla Control DE LAS LlamaradasLA Hornilla Lateral Cocción Estilo RotisserieCocinar a LA Parrilla a LA Temperatura Apropiada LimpiezaRecomendaciones Útiles INSTALACIÓN/MANTENIMIENTO DE LAS Hornillas Limpieza Y MantenimientoOperacion Apropiada DE Hornilla Continuacion DE INSTALACIÓN/MANTENIMIENTO DE LAS HornillasRejillas Para Cocinar Placas DE Distribución DEL CalorAntes DE Guardar LA Parrilla Identificación Y Corrección DE ProblemasPreguntas Frecuentes Preguntas Frecuentes Contenido DE LA Bolsa DE Partes Lista DE Partes Instrucciones DE ArmadoPage Paso Paso Paso Paso Inserte los dos tornillos que se asocian Paso Bandeja para ProSeries 9620 Armada Warranty