Brinkmann 810-6830-0 owner manual Connecting Your Grill to the Natural GAS Source

CONNECTING YOUR GRILL TO THE NATURAL GAS SOURCE

1.Coat pipe nipple with gas resistant teflon tape or pipe dope. Tighten quick-disconnect coupler onto pipe nipple that leads to natural gas supply (Figure A).

2.After grill is completely assembled, make sure natural gas supply valve is “OFF” and then connect natural gas hose to socket. Push sleeve back on socket (Figure B) and insert plug until sleeve snaps forward, locking plug into socket. Be sure to leak test these connections prior to use.

				Insert cover when hose is disconnected
(Figure A)
			Quick-disconnect
			coupler
	Natural gas supply	Pipe nipple			Plug	Hose

Supply valve Sleeve

(Figure B)

Push sleeve back to attach

Natural gas supply Hose

Supply valve Socket

Sleeve

DISCONNECTING YOUR GRILL FROM THE NATURAL GAS SOURCE

1.Turn natural gas supply valve “OFF”

2.To disconnect, push sleeve back and pull plug out of sleeve.

WARNING

•Never use your grill without leak testing all gas connections and hoses. See the section on “Leak Testing” in this manual for proper procedures.

•Visually inspect the hose assembly prior to each use for evidence of damage, excess wear or deterioration. If found, replace the assembly before using your grill. Only the Brinkmann supplied replacement should be used.

5