Brinkmann 810-6830-0 owner manual Lighting Instructions, Lighting the Main Burners

Page 9

WARNING

Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual.

WARNING

LIGHTING INSTRUCTIONS:

Follow the instructions exactly.

1.OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down.

2.Check that all burner control knobs and the natural gas supply are turned to the "OFF" position.

3.Turn on natural gas supply.

4.DO NOT stand with head, body, or arms over the grill when lighting.

LIGHTING THE MAIN BURNERS:

1. Open lid before lighting burner.

2. Make sure all control knobs are in the "OFF" position.

3.Select the burner to be lit. Push and turn the control knob of that burner to the "HIGH" position.

4. Press the electronic igniter and hold for 3–5 seconds to light burner.

5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait 5 minutes to allow gas to dissipate and repeat lighting procedure.

6. Repeat Steps 3–5 for lighting each burner. Always use the electronic igniter for lighting each burner. If burner does not ignite using push-button igniter, wait 5 minutes, see ” Match Lighting the Main Burners” section.

7.To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn off the gas flow from the natural gas supply.

Note: If burner does not light or flame is too low, you may have spider or other insect blockage in burner. See "Burner Assembly/Maintenance" under Proper Care and Maintenance.

MATCH LIGHTING THE MAIN BURNERS:

1.Open lid before lighting.

2.Turn the burner control knobs to “OFF”.

3.Strike the match and place approximately 1/2" (1 to 2 cm) above lighting hole located on right and left hand side of the grill body.

4.Turn right or left burner control knob to the “HIGH” position. The burner should light within 5 seconds.

5.If the burner does not light, turn the control knob to “OFF” and wait 5 minutes for gas to evacuate the grill. Repeat Steps 1 through 5 until the burner ignites.

6.Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the “HIGH” position.

Match

Lighting Hole

7.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See “Trouble Shooting” section of this manual.

8

Image 9
Contents Natural GAS Grill Island Important Safety Table of Contents General Warnings Installation Information Disconnecting Your Grill from the Natural GAS Source Connecting Your Grill to the Natural GAS SourceLeak Testing When to Perform a Leak TestChecking for Leaks PRE-START Check List Lighting Instructions Lighting the Main BurnersMatch Lighting the Main Burners Lighting the Rotisserie Burner Match Lighting the Rotisserie BurnerLighting the Side Burner Turning OFF the Grill Match Lighting the Side BurnerBreaking in Your Grill Operating the GrillPreheating the Grill Controlling FLARE-UPSSide Burner Rotisserie CookingCleanliness Grilling to Proper TemperatureHelpful Hints Burner ASSEMBLY/MAINTENANCE Cleaning and MaintenanceHeat Distribution Plates Cooking GrillsTransporting and Storage Before Storing Your GrillTrouble Shooting Frequently Asked Questions Parts BAG Contents Assembly Instructions For Missing PARTS, Please Call Customer Service AT Step Guide Pin Extension Cord Hole Step Support Plates Threaded Stud Washer M8 Nut Step M6 x 12mm bolt Step Attach basket bracket guide using two M5 x 10mm bolts Side Burner Place side burner grate on side burner Charmglow Grill Island Assembled DE Seguridad Índice Advertencias Generales Informations Concernant L’INSTALLATION Desconectar SU Parrilla DE LA Fuente DE GAS Natural Conectando SU Parrilla a LA Fuente DE GAS NaturalPruebas DE Detección DE Fugas Cuándo Realizar UNA Prueba DE Detección DE FugasVerificación DE Ausencia DE Fugas Lista DE Verificación Preliminar AL Encendido Instrucciones DE Encendido Encendido DE LAS Hornillas PrincipalesEncendido DE LAS Hornillas Principales CON UN Cerillo Encendido DE LA Hornilla Lateral Encendido DE LA Hornilla DEL Asador Estilo RotisserieApagado DE LA Parrilla Encendido DE LA Hornilla Lateral CON UN CerilloPreparación DE LA Parrilla Para Usarla POR Primera VEZ Operación DE LA ParrillaPrecalentamiento DE LA Parrilla Control DE LAS LlamaradasLA Hornilla Lateral Cocción Estilo RotisserieLimpieza Cocinar a LA Parrilla a LA Temperatura ApropiadaRecomendaciones Útiles INSTALACIÓN/MANTENIMIENTO DE LAS Hornillas Limpieza Y MantenimientoPlacas DE Distribución DEL Calor Rejillas Para CocinarTransporte Y Almacenaje Antes DE Guardar LA ParrillaPreguntas Frecuentes Identificación Y Corrección DE ProblemasPreguntas Frecuentes Instrucciones DE Armado SI Faltan PARTES, Llame a Servicio AL Cliente AL Contenido DE LA Bolsa DE Partes Paso Pasador de Guía Orificio para el Cable de Extensión Nota Asegúrese de que la flecha esté apuntando hacia delante Placas de Apoyo Perno prisionero roscado Arandela Tuerca M8 Paso Perno M6 x 12mm Paso Tuerca M6 Pasador de resorte Pasador de bisagra Side Burner Coloque la rejilla en la hornilla lateral Charmglow Grill Island Armada Warranty