Teledyne operating instructions Operation Model OT-2 System, Mounting Details

Page 20

3 Operation		Model OT-2 System

3.1.2Mounting the Analyzer

The OT-2 System is designed for bulkhead mounting. Figure 3-1 is an illustration of the OT-2 System and mounting hole dimensions. There are four mounting holes—one in each of the inside corners of the rigid enclosure.

Figure 3-1 Mounting Details

3-2	Teledyne Analytical Instruments

Image 20

Contents Model OT-2 Oxygen Transmitter System Model OT-2 System Copyright 1999 Teledyne Analytical InstrumentsTable of Contents Ground Model OT-2 System Introduction Introduction Model OT-2 System Front View Introduction Model OT-2 System Model OT-2 System Operational Theory IntroductionOperational Theory Model OT-2 System Micro-Fuel Cell Sensor Principles of OperationCross Section of a Micro-Fuel Cell not to scale Electrochemical Reactions Model OT-2 System Operational Theory Characteristic Input/Output Curve for a Micro-Fuel Cell Electronics and Signal Processing Sample Flow Description See Figure Piping Layout Operational Theory Model OT-2 System Installation Model OT-2 System OperationOperation Model OT-2 System Mounting DetailsGas Connections Operation Model OT-2 System Front View of Transmitter Operation Model OT-2 System Installing the Micro-Fuel Cell CalibrationSample System Component Locations Span Gas % F.S. x 4 + = Output in VDC 100 Testing the System 3 H2S ScrubberOperation Model OT-2 System Model OT-2 System Maintenance Model OT-2 System Scrubber Replacement Maintenance Model OT-2 System Appendix Qty Part Number Description Section I Product Identification Section III Physical Hazards Section V Emergency and First Aid Procedures Appendix

3 Operation

Model OT-2 System

Figure 3-1 Mounting Details