Teledyne OT-2 operating instructions Section V Emergency and First Aid Procedures

Page 37

Model OT-2 System

Appendix

 

 

 

 

 

 

Section V – Emergency and First Aid Procedures

Eye Contact:

Flush eyes with water for at least 15 minutes and get immedi-

Skin Contact:

ate medical attention.

Wash affected area with plenty of water and remove con-

 

taminated clothing. If burning persists, seek medical atten-

Ingestion:

tion.

Give plenty of cold water. Do not induce vomiting. Seek

 

medical attention. Do not administer liquids to an uncon-

Inhalation:

scious person.

Liquid inhalation is unlikely.

Section VI – Handling Information

NOTE: The oxygen sensors are sealed, and under normal circumstances, the contents of the sensors do not present a health hazard. The following information is given as a guide in the event that a cell leaks.

Protective clothing: Rubber gloves, chemical splash goggles.

Cleanup procedures: Wipe down the area several times with a wet paper towel. Use a fresh towel each time.

Protective measures

during cell replacement: Before opening the bag containing the sensor cell, check the sensor cell for leakage. If the sensor cell leaks, do not open the bag. If there is liquid around the cell while in the instrument, put on gloves and eye protection before removing the cell.

Disposal:Should be in accordance with all applicable state, local and federal regulations.

NOTE: The above information is derived from the MSDS provided by the manufacturer. The information is believed to be correct but does not purport to be all inclusive and shall be used only as a guide. Teledyne Analytical Instruments shall not be held liable for any damage resulting from handling or from contact with the above product.

Teledyne Analytical Instruments

A-5

Page 36 Page 38
Image 37
Page 36 Page 38
Contents Model OT-2 Oxygen Transmitter System Copyright 1999 Teledyne Analytical Instruments Model OT-2 SystemTable of Contents Ground Model OT-2 System Introduction Introduction Model OT-2 System Front View Introduction Model OT-2 System Introduction Model OT-2 System Operational TheoryMicro-Fuel Cell Sensor Principles of Operation Operational Theory Model OT-2 SystemCross Section of a Micro-Fuel Cell not to scale Electrochemical Reactions Model OT-2 System Operational Theory Characteristic Input/Output Curve for a Micro-Fuel Cell Electronics and Signal Processing Sample Flow Description See Figure Piping Layout Operational Theory Model OT-2 System Model OT-2 System Operation InstallationMounting Details Operation Model OT-2 SystemGas Connections Operation Model OT-2 System Front View of Transmitter Calibration Operation Model OT-2 System Installing the Micro-Fuel CellSample System Component Locations Span Gas % F.S. x 4 + = Output in VDC 100 3 H2S Scrubber Testing the SystemOperation Model OT-2 System Model OT-2 System Maintenance Model OT-2 System Scrubber Replacement Maintenance Model OT-2 System Appendix Qty Part Number Description Section I Product Identification Section III Physical Hazards Section V Emergency and First Aid Procedures Appendix
Top Page Image Contents