Agilent Technologies 54600-Series manual Display System, Measurement Features

Performance Characteristics (continued)

Display System

Display	7-inch raster monochrome CRT
Throughput of Analog Channels	25 million vectors/sec per channel with 32 levels of intensity
Resolution	255 vertical by 1000 horizontal points (waveform area) 32 levels of gray scale
Controls	Waveform intensity on front panel. Vectors on/off; infinite persistence on/off 8 x 10 grid with continuous intensity control
Built-in Help System	Key-specific help in 11 languages displayed by pressing and holding key or softkey of interest
Real Time Clock	Time and date (user setable)
Measurement Features
Automatic Measurements	Measurements are continuously updated. Cursors track current measurement
Voltage (analog channels only)	Peak-to-Peak, Maximum, Minimum, Average, Amplitude, Top, Base, Overshoot, Preshoot, RMS (DC)
Time	Frequency, Period, + Width, - Width and Duty Cycle on any channels
	Rise time, Fall time, X at Max (Time at max volts), X at Min (Time at min volts), Delay, and Phase on analog channels only.
Counter	Built-in 5 digit frequency counter on any channel. Counts up to 125 MHz
Threshold Definition	Variable by percent and absolute value; 10%, 50%, 90% default for time measurements
Cursors	Manually or automatically placed readout of Horizontal (X, ∆X, 1/∆X) and Vertical (Y, ∆Y)
	Additionally digital or analog channels can be displayed as binary or hex values
Waveform Math	One function of 1-2, 1*2, FFT, differentiate, integrate.
	Source of FFT, differentiate, integrate: analog channels 1 or 2 (or 3 or 4 for 54624A), 1-2, 1+2, 1*2
FFT
Points	Fixed at 2048 points
Source of FFT	Analog channels 1 or 2 (or 3 or 4 on 54624A only), 1+2, 1-2, 1*2
Window	Rectangular, Flattop, Hanning
Noise Floor	-70 to -100 dB depending on averaging
Amplitude Display	In dBV, dBm@50 Ω
Frequency Resolution	0.097656/(time per div.)
Maximum Frequency	102.4/(time per div.)

* Denotes Warranted Specifications, all others are typical. Specifications are valid after a 30-minute warm-up period and ±10 °C from firmware calibration temperature.

18