HoMedics BPA-100 manual Potential for RADIO/TELEVISION Interference, Troubleshooting

BPA-100IB_ENGSP.qxd 10/24/05 10:51 AM Page 27

POTENTIAL FOR RADIO/TELEVISION

INTERFERENCE

For USA only:

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the product on and off, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the product and the receiver.

•Connect the product into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

For Canada only:

This digital apparatus does not exceed the

Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled “Digital Apparatus”, ICES-003 of the Canadian Department of Communications.

Cet appareil numérique respecte les limites de bruits radioeléctriques applicables aux appareils numériques de Classe B prescrites dans la norme sur le matériel brouilleur: “Appareils Numériques”, ICES-003 édictée par le ministre des communications.

TROUBLESHOOTING

If any abnormality arises during use, please check the following points

SYMPTOMS	POSSIBLE	CORRECTION
	CAUSES
Unit does not turn on	Batteries have	Replace them with
when the START/STOP	run down.	four new AA
button is pushed.		alkaline batteries.
	Battery polarities	Re-insert the batteries in
	have been positioned	the correct positions.
	incorrectly.
EE measurement error	Cuff has been placed	Wrap the cuff properly
symbol shown on dis-	incorrectly.	so that it is positioned
play or the blood pres-		correctly.
sure value is displayed
	Did you talk or move	Measure again. Keep
excessively low	during measurement?	arm steady during
(or high).		measurement.
	Shaking of the arm with
	the cuff on.
E1 error symbol shown	Air circuit abnormality.	Check cuff connection.
on display	Cuff tube may not be	Measure again.
	plugged into monitor
	correctly.
E2 error symbol shown	Inflation pressure	Switch the unit off, then
on display	exceeding 300 mmHg.	measure again.
E3 error symbol shown	Data error.	Remove and reload the
on display		batteries.

Note: If the unit still does not work, contact HoMedics Consumer Relations. Under no circumstance should you disassemble or attempt to repair the unit by yourself. Contact information for HoMedics Consumer Relations Department can be found on the warranty page.

27 28