Omron 705CP-II instruction manual How to apply the cuff

Page 7

705CP-II English

How to apply the cuff

(when wrapping on your left arm)

• You can wrap the cuff either on your right or left arm.

￿Insert air tube to air jack (on the left side of the divice). The cuff must be airless.

￿Remove tight-fitting clothing from your upper arm.

￿Sit in a chair with your feet flat on the floor and place your arm on a table so that the cuff is at the same level as your heart.

￿Put your arm through the cuff loop. The bottom of the cuff should be approximately 1 to 2 cm above the elbow. The green marker on the cuff should lie over the brachial artery on the inside of the arm.

The tube should run down centre of arm approximately even with middle finger.

Bottom Edge 1 to 2 cm

Cuff Tube

Green Mark

6

Image 7
Contents 705CP-II Contents Dear Customer 705CP-II English Your blood pressure monitor the benefits Battery installation / replacement How to set time and date How to apply the cuff Right hand measurement How to take a reading Instructions for special conditions How to use the memory function Hints on taking blood pressure readings Failure, causes and rectification Do not use petroleum spirits, thinners or similar solvents Maintenance and storageDo not wash the cuff or make it wet Which is the Pressure Sensor, is produced in Japan Technical dataOmron spare parts Spare parts & accessoriesCalibration Some useful information about blood pressure What is Blood Pressure ?High Blood Pressure What Causes High Blood Pressure ? Introduction BatteryInstallation Replacement705CP-II English How to use the printer Date MonthsTime/Hour Specifications TroubleshootingManufacturer