Toshiba VF-A7 instruction manual When the motor is out of operation. If the monitor display

Step 2: Switching from speed control mode to torque control mode, using external terminals, and assigning the control mode switching function to the terminal S4.

R/L1	U/T1	Ｍ	R/L1	U/T1	Ｍ
S/L2	V/T2		S/L2	V/T2
T/L3	W/T3		T/L3	W/T3
S4: Control mode			S4: Control mode
			switching
RR switching
			RX
CC	CC		CC	CC

S4-CC disconnected: Speed control

Control mode	Speed control
Speed command	RR-CC (Default setting)

S4-CC connected: Torque control

Control mode	Torque control
Torque command	RX-CC(Default setting)

[Setting procedure: Assigning a control mode switching function to the terminal S4]

Key operated	LED display	Operation
		The operation frequency is displayed. (Make this setting
		when the motor is out of operation.) (If the monitor display
		mode setting parameter  is set at [Running
		frequency])
MON		Press the [MON] key to call up the first basic parameter
		 (automatic acceleration/deceleration).
▲ ▼		Select  by pressing the △ or ▽ key.
ENT		Pressing the Enter key displays extend parameters starting
		at 100.
▲		Select“” (input terminal function selection #8 (S4))
		by pressing △ key.
ENT		Press the Enter key to display the parameter setting.
▲		Change the parameter setting to  (control switching)
		by pressing △ key.
ENT	⇔	Press the Enter key to save the change. Then,
		and the set value are displayed alternately.

C-9