Toshiba VF-A7 Output of the designated data in 7 bits, Over travel On Over running

Parameter setting		Function	Operation output specifications (in case of positive logic)
Positive	Negative
logic	logic
92	93	Designated data output #1
94	95	Designated data output #2
96	97	Designated data output #3	Output of the designated data in 7 bits.
98	99	Designated data output #4
100	101	Designated data output #5
102	103	Designated data output #6
104	105	Designated data output #7
106	107	Light load signal	"ON": Load is equal to ～(Heavy load torque) set
			values or less.
108	109	Heavy load signal	"ON": Load is larger than ～ set value.
110	111	Positive torque limit	"ON": Positive torque is over the positive torque limit level.
112	113	Negative torque limit	"ON": Negative torque is over the negative torque limit level.
114	115	Output for external rush	"ON": External rush suppression relay is actuated.
		suppression relay
116	117	Over travel	"ON": Over running
118	119	Completion of positioning	"ON": Positioning has been completed.

Note 1: "ON" in positive logic:	Open collector output transistor or relay is turned on.
"OFF" in positive logic:	Open collector output transistor or relay is turned off.
"ON" in negative logic:	Open collector output transistor or relay is turned off.

"OFF" in negative logic: Open collector output transistor or relay is turned on.

Note 2: Alarm output check conditions are as follows.

1)	Under-voltage detected:	To be checked always.
2)	Low current detected:	To be checked during operation command.
3)	Over-torque detected:	To be checked always.

■Sink logic/source logic

Sink logic and source logic (input/output terminal logic) can be switched to each other. Refer to the section 2.3.2

G-8