Toshiba VF-A7 Operation from the control panel, Setting the start and stop modes, Torque command

Press the Enter key to save the change. Then,  and the set value are displayed alternately.

3.3.4 Operation from the control panel [Torque control mode]

This section describes how to set the start and stop control modes, as well as torque commands from the control panel.

■Setting the start and stop modes

To make it possible to start/stop from the operating panel in torque control mode,

[Set the basic parameter (operation command mode selection) at (operating

	panel).]
[Setting		procedure]
	Key operated		LED display	Operation
				The operation frequency is displayed. (Make this setting when
				the motor is out of operation.)(If the monitor display mode
				setting parameter  is set at  [Running frequency])
	MON			Press the [MON] key to call up the first basic parameter 
				(Automatic acceleration/deceleration).
	▲	▼		Select  by pressing the △ or ▽ key.
	ENT			Press the Enter key to display the parameter setting. (Default
				setting: )
	▲			Change the parameter setting to  (Operating panel input
				enabled) by pressing △ key.
	ENT		⇔	Press the Enter key to save the change. Then,  and
				the set value are displayed alternately.

■Selecting a torque command mode

To make it possible to set a torque command from the operating panel in torque control mode, [Set the extended parameter  (torque command selection) at  (Control panel).]

[Setting	procedure]
Key operated		LED display	Operation
			The operation frequency is displayed. (Make this setting when
			the motor is out of operation.)(If the monitor display mode
			setting parameter  is set at  [Running frequency])
MON			Press the [MON] key to call up the first basic
			parameter  (Automatic acceleration/deceleration).
▲	▼		Select  by pressing the △ or ▽ key.
ENT			Press the Enter key to display the first parameter
			.
▲			Select  (Torque reference selection) by pressing the
			△ key.
ENT			Press the Enter key to display the parameter setting.
▲			Select  (Panel input) by pressing △ key.

ENT

⇔

■Torque command

See the next page for the setting procedure.

TitleFunction

 Control panel torque command

Adjustment range ～ [%]

Default setting



C-14