Honeywell 408 manual Miscellaneous Commands cont’d, Quick Forced Arm Yes, Quick Exit, Quick Bypass

Miscellaneous Commands (cont’d)

Quick Forced Arm Yes No

If programmed by your installer, Quick Forced Arm allows you to arm the burglar portion of your alarm system in the Away mode, bypassing all zones that are not ready. To enable Quick Force Arm:

Press [#], [2].

A valid User Code is still required to disarm the system.

UL	The Quick Forced Arm feature is disabled on UL installations.
	Quick Exit	Yes	No

If enabled, this feature allows the user to exit without having to disarm, then arm the system. It is activated by pressing the [STAY] key while the system is armed and not in entry delay. This starts the exit time, causes the keypad to beep once, and allows the user to exit without disarming the system. The system returns to its last armed state after the exit time has expired.

Quick Bypass Yes

No

If you have Quick Bypass programmed for your system, you do not have to use your User Code to bypass zones. The Quick Bypass procedure is:

BYPASS , Zone No. (1-8)

Bypassed zones are not protected while the system is armed. After the Bypass command has been accepted, the keypad sounds one long beep, and the zone or zones bypassed slowly blink.

– 20 –