Paging Feature (cont’d)

1.Access pager number programming by pressing in sequence the [#], [5], and [8] keys. An acknowledgement tone sounds to indicate pager number programming has been accessed.

The [#], [5], [8] command is accessible only while the system is disarmed and the dialer, dialer delay, and bell are not active.

LCD keypads will display the existing pager phone number.

2.Enter your new pager phone number. Your new pager phone number may consist of up to 16 characters (1-9, 0). It may be necessary to add time to allow the pager to answer before dialing your pager number. To enter a 2-second pause, press the [CODE] key. (Entering a 2-second pause is optional and is not required to enter your pager phone number.) If the [CODE] key was pressed, it counts as one character. The keypad will emit a single acknowledgement chirp as each number is pressed.

3.Press the [#] key after you have made your pager phone number changes. Pressing the [#] key saves your new pager number and nulls out the remaining locations. An acknowledgement tone sounds.

To exit without saving changes, press the [] key to exit pager phone number programming. An acknowledgement tone sounds to indicate pager number programming has been exited.

If you press the [] key without first pressing the [#] key to save your new pager phone number, the system exits the pager phone number programming mode without saving the changes.

If no key is pressed within 10 seconds, the pager phone number programming mode times out and exits automatically without saving any information entered.

– 18 –

Page 18
Image 18
Honeywell 408EU manual Paging Feature cont’d